Set up the td-w89941n V1 ADSL No Line by mode diagram Step one: View the td-w89941n version number
At the bottom of the td-w89941n router, find the location of the sticker, serial The Ver (that is, version/version) in the number column as the hardware version. The following figure:
Set up the td-w89941n V1 ADSL cable-free mode diagram Step two: Set the computer IP address
Before setting up the td-w89941n routing all-in-one, you need to set the IP address of the computer to be automatically obtained (dynamic IP), as shown in the following figure.
Set up the td-w89941n V1 ADSL cable-free mode diagram Step three: td-w89941n one machine installation
Plug the telephone line into the ADSL interface of the td-w89941n machine; in the preparation of a network cable, a network cable connected to the computer, the other end of the connection td-w89941n integrated LAN interface, as shown in the following figure:
Set up the td-w89941n V1 ADSL cable-free mode diagram Step four: Set the TD-W89941N routing integrated Machine
1, in the browser address bar input: 192.168.1.1, and press the Enter button.
2, in the pop-up dialog box to enter "user name" and "Password", both by default are admin--> "OK"
3. Run Setup Wizard: Click the "Setup Wizard" on the left and click "Next".
4, select the System mode: select "ADSL No Line by mode"--> "Next".
5, choose the way of Surfing the Internet: select "PPPoE (ADSL virtual dialing)"--> "Next".
6, fill in the Broadband account and password: "Internet account" fill in your broadband username--> "Internet password" fill in your broadband password--> "next".
7, set up wireless network: "Wireless Status" selection: Open--> Set "SSID", the SSID is the name of the wireless network--> check "WPA-PSK/WPA2-PSK"--> set "PSK password", PSK password is the password of the wireless network--> "Next".
8, Setup complete: Click "Reboot", note: sometimes may not need to restart, directly click "Finish" can be.
Set up the td-w89941n V1 ADSL cable-free mode diagram Step five: Check that the settings are successful
td-w89941n No Line by one machine restart, re-enter the Setup interface, click "Run Status", and then view the "WAN status", if the IP address, subnet mask, gateway, DNS server, the following parameters have address information, the setting is successful, as shown in the following figure.
If the IP address, subnet mask, gateway, DNS server does not have any address information, all display 0.0.0.0, there is a problem with the settings, the user needs to carefully check the relevant setup steps.