How to set WDR6510 wireless settings and management with the screen

How to set the wireless setting and management of WDR6510 with screen one, wireless parameter modification

1, enter the Setup interface

In the default view, click Settings, as shown below.

Click on the wireless settings, as shown below.

2, set the main network wireless parameters

Click on the main network to set up the wireless network, as shown below.

Set the wireless name (SSID) and wireless password for the primary network, as shown in the following illustration.

After you set up the above, use the stylus to pull down the page Setup other content, as shown below.

3, set up a visitor network

Return to the main menu, click on the Visitor network, the guest network is opened by default, you can set whether to open the guest network and set the visitor name, the wireless password cycle (automatic change) as shown in the following figure.

4, Wireless timing settings

Wireless timing settings can set wireless for a specific time period to turn off the router, as shown below.

If you need to set up a wireless timing, please click and add time and corresponding week, can be added or deleted, the following figure.

5. Save Settings

Click Back,

You will be prompted to save settings information and restart, click on the restart immediately, as shown below.

After the reboot, the wireless settings take effect, the notebook, mobile phone can search the signal and connect to the Internet.

How to set the wireless setting and management of WDR6510 with screen Two, visitor password view

1, access to the main interface

Enter the main interface, as shown below.

2, switch to the network interface of visitors

Click on the arrow to the right and switch to the visitor network interface, as shown below.

In this interface to view the dynamic password of the guest network, you need to access the Visitor network terminal to enter the password can be, the following figure.

Note: The dynamic password for the guest network changes according to the update cycle that was previously set.

How to set the wireless setting and management of WDR6510 with screen three, wireless state observation

1, access to the main interface

Enter the main interface, as shown below.

2. Switch to Wireless status

Click the arrow to the right and switch to the Wireless Status page (second page), as shown below.

View the connected wireless devices and corresponding states in the interface, as shown in the following illustration.

Click on the attached device, you can observe and control the wireless devices that have been connected, as shown below.

You can observe the name of the wireless terminal, wireless rate, MAC address, IP address, click Disable to prohibit the device to connect to the wireless network. The following figure.