This paper introduces the application and configuration of TL-MR22U in client mode.
The application topology where TL-MR22U works in client mode is as follows:
Application topology of TL-MR22U client mode
1
Confirm the wireless parameters of the primary router
Confirm the name (SSID), encryption method, and password of the wireless signal to be connected. The following table is used as an example:
Note:The WPA-PSK/WPA2-PSK is the same as the WPA/WPA2-Personal Edition. The parameters in the preceding table are for reference only.
2
,
Set a computer wired Nic
Before setting a vro, you need to set the wired network card of the operating computer to automatically obtain the IP address. If you do not know how to set it, refer:
Pull the pattern switch of the TL-MR22U
AP
Mode, As shown in the following figure:
1
, Enter the management address
Open the browser on the desktop, clear the address bar, and enter
Tplogin.cn(Management address). After you press enter, the logon box is displayed.
2
, Logon Management Interface
If this is the first login, you need to set the management password of the router. In
Set password
In
Confirm password
And click
OK. If you have set a password, enter the password to go to the management page.
If you cannot log on to the management page after entering the management address, click to reference:
1
Start setting Wizard
Go to the vro management page and click
Setup Wizard, Click
Next Step.
2
, Select work mode
Select
Client mode
(
Client
), Click
Next Step.
3
, Scanning signal
Click
ScanTo find wireless signals.
4
,
Select the main router signal
Find the SSID of the primary router on the scan page, and click
Connection.
Note:: If the signal of the primary router is not scanned, make sure that the wireless feature is enabled on the primary router and try to reduce the distance between the primary router and the secondary mini router.
5
Enter the wireless password
Select the same key type as the master router
WPA/WPA2-
Personal Edition, In
PasswordEnter the wireless password of the master router and click
Next Step.
6
, Restart the router
Click
CompleteIn the displayed dialog box, the system prompts you to restart. Click
OK.
After the router is restarted, the computer attempts to access the Internet. If the access succeeds, the Client mode is successfully set.
Now, the Client mode settings are complete. Computer wired connection in the TL-MR22U, automatically get to the IP address to access the Internet