How to use PS to make micro-letter Home

1, open the micro-letter image.

2. Use the Clone Stamp tool to remove the characters and shadows from the original artwork.

3, open to replace the material picture, buckle the need for the part, and then copy to have been removed from the original character of the micro-letter boot screen map, resize to position.

4, load the selection, fill the black, using the eraser tool to remove the edges of the clean parts.

5, next need to do a shadow, this need to understand the direction of the light source, where our default light source in front. Copy the character layer, flip, elongate, because this character is off the ground has a certain area, so the shadow also must be a certain distance from the horizon, this is common sense, it is not much to say.

6, next, to give the shadow to make a deep and shallow gradient, I was in the mask directly pull the black and white gradient, you can also use the eraser or brush tool directly erase, fade too thick parts.

This simple 6 steps on the completion of the micro-letter home changes, will be a single lonely person moment into the rescue of the new image of the Earth, is not that cool.

Category:

• PS Getting Started Tutorial
• Micro-Credit Tutorial