How to use the DiskPart command line partition

Here, let's take a look at the use of the DiskPart command line partition, where I started the Waik PE, but this command does not require PE, you can also perform on your own computer

List Disk from the word we can see that this is the list of all the disks, where I have only one disk 0

Now we want to 0来 the disk operation, before the operation to select the DISK0

We can use the list partition command to view our existing partition information, the following figure, there are two partitions, we have to demonstrate the deletion of the operation, the same, we want to delete who will first select who, and then execute the delete partition

Once the deletion is complete, when we perform the list partition again, there is no information on any partitions, and this time we can create a partition to allow us to install the system

create partition is creating partitions

Primary, this is the primary partition.

Size=xx It's pretty obvious how big this partition is.

Once we're done, we'll see how much space there is left in this disk 0, 97GB

The command to allocate the rest of the space to a new partition is the create partition primary. Do not add size, that is, give the rest to the new partition