How to use the Tp-link QSS button to set an Extender

Use the Tp-link qss button to set how the Extender is used

1, find the QSS button location on the router and extender

2, click the QSs button on the router

3, click the QSs button on the Extender

At this point, the extended operation Setup is complete and we are down to confirm that the extension was successful.

Use the Tp-link qss button to set the Extender to confirm the successful method of the signal extension

Try to observe the LEDs of the Extender, if it is green or orange, to indicate that the extension succeeded, as follows.

Warm tip: Orange indicates that the Extender is too close or too far from the main router to adjust the position appropriately.

At this point, the default signal of the Extender disappears, has become the same as the main router signal, the wireless name and password are the same. Your phone is connected to the extended signal, you can access the Internet.