The application topology of TL-WR700N working in Client mode is as follows:
Application topology of TL-WR700N Client mode
1
Confirm the master router parameters
Log on to the management interface of the wireless router (that is, the primary router) to be connected, and confirm the SSID, wireless password, and other parameters. The following parameters are used as an example:
SSID:Zhangsan;
Wireless password: 1a2b3c4d.
2
,
Set a computer wired Nic
Before setting a vro, you need to set the wired network card of the operating computer to automatically obtain the IP address. If you do not know how to set it, refer:
Pull the pattern switch of the TL-WR700N
AP
Mode, As shown in the following figure:
1
, Enter the management address
Open the browser on the desktop, clear the address bar, and enter
Tplogin.cn, And the login box will pop up after you press Enter.
2
, Logon Management Interface
If this is the first login, you need to set the management password of the router. In
Set password
In
Confirm password
And click
OK. If you have set a password, enter the password to go to the management page.
If you cannot log on to the management page after entering the management address, click to reference:
1
Start setting Wizard
Go to the vro management page and click
Setup Wizard, Click
Next Step.
2
, Select work mode
Select
Client: Client mode, ClickNext Step.
3
, Scanning signal
Click
ScanTo find wireless signals.
4
,
Select the main router signal
Find the SSID of the primary router on the scan page, and click
Connection.
Note:: If the signal of the primary router is not scanned, make sure that the wireless feature is enabled on the primary router and try to reduce the distance between the primary router and the Mini router.
5
Enter the wireless password
In
KeyEnter the wireless password of the master router and click
Next Step.
6
, Set, restart the router
Click
Restart, Click in the pop-up dialog box
OK.
Log on to the TL-WR700N management interface, click
Running status, Observe
Wireless status
>
Connection status, Display
SuccessfulThe Client mode is successfully set.