Huawei Switch Istack Stacking configuration

Topology diagram:

650) this.width=650; "src=" Https://s4.51cto.com/wyfs02/M01/8C/F3/wKiom1h_CpuDD5ztAAAd2JyxG5Q856.png "title=" 32323232.png "alt=" Wkiom1h_cpudd5ztaaad2jyxg5q856.png "/>

Sw-a

Interface Stack-port 0/1

Port int XG0/0/23 Enable

Port int XG0/0/24 Enable

Quit

Stack slot 0 Priority 200//Modify the master switch with a stack precedence of 200, which is greater than the other member switches. Stack ID

The default value of 0 is therefore not configured.

Sw-b

Interface Stack-port 0/2

Port int XG0/0/23 Enable//This port stack will become XG1/0/23 after successful stacking

Port int XG0/0/24 Enable//This port stack will become xg1/0/24 after successful stacking

Quit

Stack slot 0 Renumber 1//stack priority with default value of 100. Modify the Stack ID to 1. After the change, the port on this switch becomes 1/x/x.

Note: The Stack-port 0/1 of this device must be connected to the Stack-port 0/2 of the neighboring device, otherwise the stacking build is unsuccessful.

To remove a stack:

1. Remove the stacking cable between the member switches. When the stacking cable is removed, the stacking system splits, causing some member switches to restart. Remote logins may not be successful due to the same partial configuration as the stack member switch IP address, so you can log in to the switch via the console port for subsequent configuration.

2, Execute command system-view Enter the system view.

3. Execution of orders Interface Stack-port member-id/port-id, enter the logical stack port view.

4. Execution of ordersShutdown Interface { Interface-type Interface-number1 [  to Interface-typeInterface-number2]} &<1-10>, close the physical member port.

5. Execution of ordersUndo Port Interface{ Interface-type Interface-number1 [  to Interface-typeInterface-number2]} &<1-10>Enable, restore the physical member port to the business port.

6. Execution of orders quit , Exit Logic Stacking Port.

7. Execution of ordersStack Slot Slot-id Renumber 0, set the member switch'sStackingthe ID reverts to the default value of 0.

8. Power down the member switch.

This article is from "I'm Still alive" blog, please be sure to keep this source http://hujizhou.blog.51cto.com/514907/1892874

Huawei Switch Istack Stacking configuration