Huawei VLAN Division, single arm routing and static routing

Huawei VLAN Division, single arm routing and static routing enable all members to access the Internet

Huawei topology Map:

IP address planning as shown!

IP Address

VLAN Partitioning:

[Huawei]un in EN close Message center

[huawei]sysname SW1 Change switch name

[Sw1]inter VLAN 1 into the switch

[Sw1-vlanif1]ip address 192.168.0.10 24 with IP addresses

[Sw1-vlanif1]un Shut Open

[Sw1]vlan 2 Set VLAN

[Sw1-vlan2]vlan 3

[Sw1-vlan3]vlan 4

[Sw1]inter E0/0/2 into VLAN

[Sw1-ethernet0/0/2]port link-type Access

[Sw1-ethernet0/0/2]port default VLAN 3

[Sw1-ethernet0/0/2]inter E0/0/1

[Sw1-ethernet0/0/1]port link-type Access

[Sw1-ethernet0/0/1]port Default VLAN 2

[Sw1-ethernet0/0/1]inter E0/0/3

[Sw1-ethernet0/0/3]port link-type Access

[Sw1-ethernet0/0/3]port Default VLAN 4

[Sw1-ethernet0/0/3]inter G0/0/1

[Sw1-gigabitethernet0/0/1]port link-type Trunk set to Medium port

[Sw1-gigabitethernet0/0/1]port trunk Allow-pass VLAN All

Set all members through