Huawei HG8240 Fiber Cat How to turn on routing function

About HG8240 Fiber-optic cats Many people say that they can not open the way by, or unsuccessful. In fact, it can open the route, because he is three layers. At least I am currently in use, but also to help customers open the success can be at the same time 4 machines.

It's easy to turn on, no technical content,

1. IP to set the IP 129.168.100.1 Super username telecomadmin password of the 192.168.100.2--254 login cat admintelecom

Language selection

2. First to the left to find the tree directory LAN, into the Lan1-4 box to see him all hook up after the application.

3. Then find the WAN Tree directory to go in, if the original inside built all delete whatever, there is no need to directly create a new, select the Internet

So that can be ticked, LAN ID and 8210P did not delete the original before some remember to copy down, fill up. There are no installers to find. Select the middle function, the way to dial PPPoE, and then fill in your own broadband account and password, the final lan1-4 also check. The application is OK. Take a moment to see the state. If the show PPPoE has IP is successful, no is not successful, start my also not the reason is the LAN ID and 8201P wrong. I am afraid to say what the two values are, and mine is 45 and 0. The beginning was 46 and 1 dead. It would be nice to change it. If you see the status where PPPoE dial-up successfully displays IP, you can set the tree directory below to find the save the current settings to flash, write it in, so restart will not be restored. If you do not save a power or reboot after the cat has not been restored to the original state. Need to start over again.

4 can refer to the following basic configuration 3 there: from the Internet

Conf t

VLAN 20 "This ID is based on"

Name Test 20 "This is named"

Exit

There's a limit to the ID here.

I'll give you the ID range and explanation.

1.0 and 4095 are limited to system use users cannot view and use

2.1 Normal Cisco default VLAN, user can use but not delete

3.2--1001 is normally used for Ethernet VLAN, which users can create. Use. Delete.

4.1002--1005 The Cisco default VLAN that is normally used for FDDI and token rings, users cannot delete

5.1006--1024 reservation is limited to system use only. User cannot view and use.

6.1025--4094 Extension for Ethernet VLAN only

It says three floors. That means a port with a cat telephone network digital TV. If you open the route after the phone and network TV will not be used.

If you want to leave the phone network Digital TV port, then add a routing bar. Settings are no different than normal routes. The routed WAN port can be connected to the LAN1 port of 8240, the IP will be filled with the route, so that it can retain the original three layer can also achieve the routing function.

Note : More wonderful tutorials Please pay attention to the triple computer tutorial section, triple Computer office group: 189034526 welcome you to join