P9 How to brush machine (line brush package + Save Brick Package)

1: The above download the Brush machine package on the computer for decompression, the following figure, and then unzip out there is a folder, folder there are two folders, a folder inside the brush machine tools, a folder inside the Rom file, a will be used.

2: Install the Brush machine tool, in the unpacked folder directly find EXE format files to install, until the installation is completed

3: The next mobile phone to enter the FastBoot mode, enter the method: In the hands of the machine state, hold down the volume reduction and power button, when the screen appears an Android robot has entered the FastBoot mode, as shown in the following figure:

4: Next to the data line to connect to the computer, waiting for the computer to load a good mobile phone driver, when the computer Device Manager shows an Android device is driving the normal

5: Then open the brush machine tool that you just installed

6: Then click the small arrow next to the Browse button, select Advanced Settings, find the "Flash_all_except_data_storage.bat" file in the Rom folder of the thread brush package you just unzipped, and click OK

7: Then click on the "Brush Machine", began to brush the phone line.

8: Wire Brush time According to each computer is different and long and short, generally not more than 200s, and then restart on it, OK, the above is a small set for you to organize an article on the P9 How to Brush machine (thread package + Save brick Package) effect as shown below.