Huawei S5700 switch Opens Web configuration

Recently a lot of friends asked about S5700 to open the Web is not successful, and now to sort out the specific steps and commands.

Hint: When the Huawei switch is configured, enter the first few letters of the command, press TAB to complete the command automatically, such as the system view of the input SH press TAB will automatically add the command to show.

1. After logging into the switch, first view the switch files and then load the Web files. Execute the command dir:/flash view the Web file name and copy it, the file name is generally xxx.web.7z or xxx.web.zip.

2, execute the command System-view into the system view.

3. Execute command HTTP server load < Paste the copied file name here > , load the Web file.

4. Execute command HTTP secure-server enable to enable HTTP security services < Some versions are turned on by default, such as prompt for error can be directly performed next >.

5. Execute the command HTTP Server enable to enable HTTP service.

6, configure user name, password and user permission level, execute command AAA, enter AAA view.

7. Execute Command local-user < user name > Password cipher < password > .

8. Execute command local-user < user name > Privilege level 15, configure user rights to 15, maximum permissions.

9. Execute Command local-user< user name >Service-type http, configure the user's access type to HTTP, some versions may be executed Local-user < user name > Service-type http web or Local-user< user name >Service-type Web, can be executed Local-user< user name >Service-type? To view the specific parameters.

10. Execute the command quit and exit the AAA view.

11, execute the command user-interface vty 0 4, enter the Vty user view of 0~4.

12, execute the command authentication-mode AAA, configure vty User's authentication interface is AAA.

13. Execute command protocol inbound all, configure the Vty user interface to support the protocol for all.

14, execute the command quit, exit the current vty User Configuration view.

15, execute Command interface vlanif 1, go to VLAN 1 configuration view.

16, execute the command IP address x.x.x.x 24, configure the Management VLAN with the x.x.x.x mask of 255.255.255.0.

17. Execute the command quit and exit the VLAN configuration view.

18. Execute the command quit to return to the user view.

19. Execute the command save and save the current configuration.

20, change the computer's IP to the same network segment as the switch, enter "https://IP/" or "http://IP/" in the browser, and the Web login switch.

This article is from the "sec-tech" blog, please be sure to keep this source http://miaolink.blog.51cto.com/4146620/1874644

Huawei S5700 switch Opens Web configuration