To you illustratror software users to detailed analysis of the design of soft vector spiral shape of the drawing tutorial.
1. Click the "line tool" in the Illutrator Toolbox and hold down the left mouse button, and then display the hidden tool from which to select "Helix Tool".
2. Hold down the left mouse button on the canvas to drag a helix, as shown in Figure 2. Note You should set the fill color to none before drawing, and the stroke can be selected arbitrarily.
Tip: When you draw a helix, clicking the canvas pops up the Helix dialog box, where you can create a helix by entering a specific value in the dialog box. And the use of drag method can be flexible to draw spirals, the specific techniques are as follows: Drag the same time by the up or down of the method keys can change the angle and direction of arc bending, hold down the SHIFT key while dragging can limit the angle of the helix, so that it at 45 degrees angle of the integer, Hold down the ALT key while dragging can change the wrapping direction of the helix, hold down the ~ key while dragging can draw more than one helix, hold down the CTRL key while dragging can change the distance between the helix, drag the space bar can move the position of the helix.
3. To maintain the selected state of the Helix, press the shortcut key CTRL + C copy, and then press Ctrl+f to paste it in front of the original position.
4. Select the "Rotate Tool" in the Toolbox, click the center of the helix, and then drag the left mouse button to the right to rotate a little, as shown in Figure 3.
4. Select the "Selection Tool" in the toolbox, change the size of the helix and move its position appropriately to get the result as shown in Figure 4.
5. Select the Zoom tool in the Toolbox, and then press the left mouse button in the center of the Helix and drag, local zoom in, and use the direct selection tool to fine-tune the end of the curve here, as shown in Figure 5.
6. Use the Direct selection tool to select the two endpoints of the two helix centers, and then press the shortcut key ctrl+j to weld them together, select the Corner radio button if the Connection dialog box appears as shown in Figure 6, and then click OK. This dialog box occurs because two anchor points overlap.
7. Use the direct selection tool to select the outermost two endpoints of the two spirals and then press CTRL+J to connect them together. At this point the two spirals become a closed path, as shown in Figure 7.
8. Use the Select tool to select the closed path and then fill it with a desired color and set the stroke to none, as shown in Figure 8.
9. Place the resulting helix in the appropriate position, as shown in Figure 9.
With the same graphic color as the target location, you get the desired effect, as shown in Figure 10.
Finally, we add a spiral pattern of colored stripes to the design, as shown in Figure 11.
Well, the above information is small set to you illustratror of this software users of the detailed design of the soft vector spiral shape of the drawing tutorials to share the full content of the users see here is now very clear how to draw the bar, Then everyone will go to follow the small part of the above to share the tutorial on their own to draw a test effect bar.
