Image Creation: use fireworks to create a tearing Effect

As a matter of fact, there is no talent for graph creation. How can we use color and other things stably? However, some small things are quite willing to explore. In the past, I used to make a picture to achieve the effect of cutting edge. on the net, I checked that PS was used directly. Some of them only had fireworks and didn't use ps. I always thought that the software was too big and the computer ran slowly, in addition, I have advanced skills in graph creation, so I am exploring it myself. The result is not done for a while. I forgot how to do it today. I thought about it for a long time, so I just recorded it here and will come back to the workshop after I forget it.

 

Let's get down to the truth and find a picture first. Open in fireworks. Then draw a rectangle below the image.

 

 

The default color here is black. Do not change the color to Black it first, and then select the edges in the filter alien skin splat le.

In addition, even fireworks 8 and CS3 do not seem to have this option, which is one of the reasons why I have been thinking about it for a long time today. I did not find this function, so I even uninstalled CS3 and reinstalled it back to fw8. Now it seems that the only problem is that it is not compatible with PSD files.

 

After edges is selected, the page appears like this ~~

 

 

Edge mode in this example can be selected. I want to perform various processing on the edge of the rectangle, so I chose torn paper directly, you can adjust the preceding values to set the size and margin of the edges. There may be a lot of truth and data, but I am a real-person in image thinking, you have adjusted the data yourself.

P.s. this is also the reason why the previous rectangle does not adjust the color, because the background is transparent, so if the color of the previous rectangle is changed to white, it will be very troublesome to judge the shape here, it is not as intuitive as black looks.

 

If it is set, OK. Return to the previous interface. This time, adjust the rectangle to white, and then adjust the position. It looks like it is a bit torn.

 

Now it looks relatively flat. Next, select the inner shadow. In fact, in principle, the relief effect should also be acceptable, but after my practice, I feel that the inner shadow effect is better.

 

 

As for shadows, if you use a teacher to make a picture, black projection will be a little bit too much, and it will be much better if you change it to Gray. Let's look at the remaining values ......

The effect is as follows:

 

Generally, I like the side, so I just copy the following and use the "Tilt" to turn it 90 degrees. After the vertical, the horizontal rectangle and the vertical rectangle will have a cross place, which is not very nice-looking. It is good to use a brush to white it. The final result is as follows:
 

This effect should be much worse than a good figure, but I still have a little sense of accomplishment.