Installation and use of some LinuxSVN

For more information about how to install and use LinuxSVN-Linux Enterprise Application-Linux server application, see the following. SVN Introduction

The goal of the Subversion project is to build a version control system that is a compelling replacement for CVS in the open source community. the software is released under an Apache/BSD-style open source license.

SVN is a version control software, similar to CVS, but SVN is a bit open-source, and the version control capability of SVN is much stronger for CVS.

SVN can be used for project management and version synchronization, but it is very powerful :)

Download: http://subversion.tigris.org

Current stable version SVN1.32http: // subversion.tigris.org/downloads/subversion-1.3.2.tar.gz

Installation:

Unzip: #: tar zxvf subversion-1.3.2.tar.gz

Enter./configure, make, and make install in sequence to complete compilation and installation.

Enable the SVN service: svnserve-d

Check whether the service is enabled: netstat-ntlp. If the port 3690 is enabled, it indicates that SVN is enabled.

Official Use:
First, we need to build a SVN project. Most people think that only one file is needed to create a project. Before I use SVN for the first time, I think that folders need to be created to create a project in SVN.

Run the "svnadmin create project_name" command to create a project.
After the creation is complete, project_name is a folder and you can see a conf folder. Go to the folder and you will see two files (if there is no passwd file, you can create it with vi). Edit svnserve. conf and set anon-access = read, auth_access = write
Also, remove the comments of password-db = passwd and [general.
Vi passwd file. If it is a new file, enter:
[User]
Your_name = your_password
Your_name is your username and your_password is your password. This is a necessary pass to access SVN.


Now we have finished the preparation. We can use it below.
First, find the source code folder of your project and run the following command:
Cd your project
In your project dircetory
Use: svn co/home/project_name -- username = your_name -- password = your_password

Now, you can use the following command on the client to obtain the project source code file you want.
Svn co svn: // home/project_name -- username = your_name -- password = your_password

Add the added svn file to the svn database:
Svn add/home/your_project/*. * -- username = your_name -- password = your_password

Submit the file:
Svn commit/home/your_project/*. * -- username = your_name -- password = your_password

Update file: svn update/home/your_project/*. * -- username = your_name -- password = your_password

Of course, you can edit a script file to complete all operations at one time:
Vi svnupdate. sh

#! /Bin/sh
Svn add/home/your_project/*. * -- username = your_name -- password = your_password
Svn commit/home/your_project/*. * -- username = your_name -- password = your_password
Svn update/home/your_project/*. * -- username = your_name -- password = your_password

Chmod + x svnupdate. sh

Finish