R410 R510 R610 R710 R810 R910 Series Server
IDRAC6 Remote Control Card requirements:
Before the implementation of the virtualization project, the purchase of the server has its own remote control card, mainly used to implement remote server management, such as remote switch, fault scheduling, such as Remote Installation system, and so on, do not need to the server hardware side, the same can be remotely operating hardware settings. It is extremely convenient to remotely administer the Dell R410 R510 R610 R710 R810 R910 series servers.
First, the machine environment:
Model: Dell R710, Dell R810, Dell R910
Control Card Model: Integrated Dell Remote Access Controller 6-enterprise Edition
Second, the remote control card configuration
Note that the remote control card has 2 versions, one version can only view information, not control, another version is the Enterprise version.
General information on the web said that the need to switch the machine to carry out remote control card configuration, in fact, is not the case, the remote control card on the R810 model is the default, there are initialized IP address, username, password, estimated each model of the Dell server initialization information is inconsistent, Can communicate with Dell technical support specifically.
Default Dell IDRAC6 Remote control card:
(R810 model of the remote control card default IP is 192.168.0.120, user name is root, password is Calvin, through the https://192.168.0.120/index.html login, do not forget to modify the password. )
The Dell next-generation server, R710, adds a new feature, which is the remote control feature. It can do remote switching machine, view the system State, Remote screen view operation, remote installation, etc., is really convenient. This for offsite storage server, greatly saving the operation of the cost, below I would like to say a R710 remote control settings method.
Use of the DELL iDRAC6 Remote control card (R710 Remote control card)
First, network settings
Boot, and so appear ctrl+e prompts, press ctrl+e into the IDRAC6 settings interface. Set iDRAC6 LAN,IPMI over LAN Two items are on state.
* Select LAN parameters to enter, set up the corresponding IP related information under IPV4 settings, this IP is to remote control need, can use this IP to control this machine remotely. When set, return.
* Select LAN User Configuration set the corresponding account number, password.
"Save all after the exit and reboot the computer." 】