Liunx System (CENTOS6) used in this tutorial: http://download.csdn.net/download/yichen01010/10016202
Install VMware first.
Double-click the install file to display the Welcome screen:
Then click Next:
Here choose Typical, continue next, then select the installation destination path, until completed, there is a step in the middle to enter the serial number, online search one can, relatively simple, not introduced, after installation to restart the computer.
Installing CentOS in two VMware
After rebooting, open the installed VMware, select File-new-virtual Machine,
Choose Custom,next here:
Select workstation6.5-7.x, Next:
Choose the third item here, install it later, and make it easy to configure. Select I'll install the operating system Later,next:
Choose Linux,version here to choose CentOS, because it is 32-bit, so do not choose Centos-64bit,next:
Select the path where the image file is stored, enter the virtual machine name and the installation path, Next:
Select the number of CPU cores allocated to the virtual machine, and VMware will warn you if the number of CPUs selected for the virtual machine exceeds the actual number of native CPUs. Next:
Virtual memory allocation, generally choose the default 1024MB on the line, Next:
Here is the network type assignment, the network type allocation divides into three kinds, bridge,nat and host-only, the approximate difference is
1 BRIDGE: Equivalent to the host and virtual machine connected to the same hub, virtual machines and hosts configured on the same network segment
2 NAT: Using VMNET8, the host to open the necessary VMware services, such as Vmvare DHCP, virtual machine set to DHCP mode, of course, can also be manually set to vmnet1 the same network segment, more trouble
3 host-only: Use Vmnet1, direct and host interconnect, can use Ifconfig to view the configuration situation
Choose Nat,next here:
Select the IO controller type, select the default, Next:
Select the virtual hard disk type, here to create a, next:
Select the type of disk you want to create, select the default, Next:
Select the size of the disk space by default
Set the virtual image file name, default, Next:
Create complete, confirm virtual machine information, click Finish.
Second, CentOS6 installation
On the virtual machine that you just created on VMware, right-click the settings
Select the system image to install (the mirror address used in this tutorial: http://download.csdn.net/download/yichen01010/10016202)
Then click "Power on" to start the virtual machine.
Wait for Setup to initialize
Right click on install to hard driver click (open)
Installation language (select English)
Install storage (select Basic Storage driver)
Wait
Select a time zone (choose one anywhere in Asia, you can change it later)
Enter the Super Administrator password (user name defaults to root)
Choose to replace the original Linux system
Select Change write to drive (write changers to disk) and click Next
Wait a minute and it will show your Centtos installation is complete.
Indicates that the installation is complete, click Close
Click System (System->shut down) to restart
After rebooting, go to the System Configuration page (drag the scroll bar, click Forwar)
Select Yes to continue forward
Temporarily do not set the user, continue to forward
After modifying the date and time, click Forward
Liunx System Installation Completed (enter the landing page) Enter the user name, the default user name is root
Enter password: Just set it up at the time of installation
See the following page, done!!!
Installing CENTOS6 Graphics installation tutorials under VMware