Introducing the software of the Wireless Router password cracking tool

The following describes the software used to crack the password of a wireless router. You can download the software from many websites. We hope to get the desired results. A wireless LAN scanning and key cracking tool, including airodump and aircrack. It can monitor data transmitted in wireless networks, collect data packets, and calculate the WEP/WPA key. Composition of the experiment environment system.

Hardware environment of the Wireless Router password cracking tool

Select a wireless router or AP with WEP and WPA encryption functions, and two laptops with a chinanceids (STA1 and STA2, respectively) as valid wireless access users ), capture a wireless network card, u a laptop (defined as STA3, as an intruder ).

Software environment of the Wireless Router password cracking tool

Hacker STA3: WinAirCrackPack toolkit. Note: To enable STA3, choose Control Panel> Administrative Tools> services to enable the Wireless Zero Config service.

Experiment topology of the Wireless Router password cracking tool

Connect the wireless router to STA1 (unencrypted by default ). Right-click the icon on the screen and select "view available wireless networks". The window shown in 1 is displayed. It shows that there are multiple available wireless networks, double-click the TP-LINK to connect to the wireless router, then the connection is successful.

Open IE and enter IP Address: 192.168.1.1 (default lan ip address of the wireless router ). Log on to the wireless router Management Interface (username: admin, password: admin ). Click the "LAN port settings" option under "Network Parameters" on the left side of the interface, set "ip address" to 192.168.1.8, and save it, as shown in figure 4.

Open IE browser, enter the IP Address: 192.168.1.8, log on to the wireless router Management Interface (note that this experiment selects the TP-LINK wireless router, other brands such as CISCO products have similar configuration options ), click the "Basic settings" option under "Wireless Settings" on the left side of the page.
◆ Set "Mode" to "54 Mbps (802.11 GB )";
◆ Select "Key format" as "ASCII code ";
◆ Set "Key type" to "64-bit ";
◆ Set "Key 1" to "pjwep ";
◆ Click Save ".

After the WEP Key is set for the wireless router, STA1 needs to reconnect to the wireless router (the entered key is the same as the key set for the wireless router), and the connection will be successful in a short time. Open IE browser, enter IP Address: 192.168.1.8, log on to the wireless router Management page again, click "DHCP service" option under "DHCP server" on the left side of the page, click "not enable" and save, click "restart vro" under "System Tools" to restart the vro. Wireless Router password cracking tool: http://www.jfsky.com/SoftDown/SoftDown_35985.html