Introduction to the problem of the IPhone 6s mobile phone after water intake

IPhone 6 has no signal after water intake

　　PRIOR statement: Apple June only provide advice, do it must be considered clearly, bad apple June do not assume responsibility, bad apple June do not assume responsibility, bad apple June don't assume responsibility important words to say three times.

Mobile Phone Repair steps:

First turn on the view, there is baseband! But no signal! Because it is a water machine, after dismantling, first clean up the motherboard, after cleaning up the fault is still the case, add some rosin in the intermediate frequency and around the small parts, with a wind gun welding for a while, troubleshooting.

IPhone 6 After water treatment boot prompt temperature is too high?

Through the inspection, add electric test machine, observe the current due to normal, the computer will not heat.

If the current is normal, this phenomenon is the temperature detection of the component damage caused by the removal of temperature detection components can be. If it is a large current situation, then the first to eliminate the problem of large current (in accordance with the maintenance of leakage method maintenance), in addition to some of the machine with power meter power-on will appear this situation, with the battery will not.

There is also one of the most common problems, is the boot line!iphone6 Flash (LED) in the boot line, there is a flash temperature detection signal to the Flash IC, the Boot line interface, replace the boot line! Replace the Flash ic!

Basic treatment after water intake

1. Get out of the water as quickly as possible (this is nonsense)

2. Press and hold the power button to shut down the machine

3. If there is a mobile phone shell, the iphone from the phone shell out, screen protection film if there is no obvious bubble does not matter, do not need to tear down

4. Use clothes or any handy cloth or paper towel as much as possible to dry and clean the water on the iphone, especially the power button, volume keys, etc. may have sewn places.

5. If there is a cotton swab around, the headphone jack in the water suction dry, if not, the paper towel into the suction water, careful not to let the paper towel rotten in the inside can not get out.

　　 Advanced treatment after water intake

1. Find a bag that can be sealed

2. Fill a bag of rice

3. Put the iphone in for at least 36 hours

4. It is important to note that do not use the kind of rice powder, the use of ordinary rice on the line, the other is that time must be long enough, so that Rice can be the iphone in the water sucked dry

5. After waiting for 36 hours, make sure that there is no moisture on the phone and try to boot.

6. If the character is good enough, your mobile phone will be like this:

　　 How to tell if the iphone has been in the water

Apple has done a lot to prevent the water from being sold, which provides water indicators from the start of the first iphone, as shown in the following illustration: