Specific methods
Method One, restart the wireless switch
1. Click "Set > Wireless LAN" On the ipad page click "Blue Arrow"
2. Then we'll "ignore this network"
3. After a while our system will prompt, whether to ignore this network, we click "Ignore", as shown in the following figure
4. Then we scan the wireless network, reconnect and enter the corresponding wireless password.
method Two, restore the mobile network
1. Or the "Setup" on the ipad panel
2. Find "General", in the window we click "Restore", click to enter
3. Next find "Restore network settings," as shown in the following figure
4. Click "Restore network Settings", the system will prompt us this operation will "remove all the IPad network settings, and restore to the factory state", as shown in the following figure
5. Click "Restore" and the system will initialize the network settings. Next we find our wireless network in the wireless, enter the corresponding wireless password, reconnect.
Method Three home routing multiple reboots several times, so that you may grab a dynamic IP address.
1. The router's power is disconnected, then reseat the power supply, forcing the router to reboot.
Friendly Tips
If it's still not going to work, we'll reset the route password again, most likely the routing password has been modified, and you'll remember the previous wifi password.