Jinlang wireless router sets up the home wireless network mode

Jinlang wireless router sets up the home wireless network mode. Today we will introduce the jinlang wireless router, which is often used to build a home wireless network. Currently, the home wireless network consists of three parts: A wireless router, wireless network card, and Wireless AP. 1. wireless router: it is also a Broadband Router used to connect to a wireless network card to achieve a network shared connection of the wireless LAN. 2. Wireless Network Adapter: it is installed on a computer and used for wireless connection between the computer or between the computer and the AP and router. 3. Wireless AP: used for signal relay amplification and communication between the wireless network and the wired network. Its function is similar to that of a switch.
I. Wireless Broadband Router + Wireless Network Card 1. Currently, most families use the Wireless Broadband Router + wireless network card mode. In this mode, both the wireless network and the wired network can be used at the same time, and the signal may be poor, this is because the resources of the wireless router are limited. 2. The advantage is that for users who use virtual dial-up software to access the Internet, they no longer need to use a computer as a gateway for dial-up. Now they can access the Internet and stay online forever. 3. For new ADSL users, it is recommended that you determine whether the broadband service has been activated before installation, and then check whether the Wireless Broadband Router, network cable, wireless network card and drive disc are complete.
2. Wireless AP + wireless network adapter www.2cto.com 1. The addition of Wireless AP enriches the networking mode. Wireless AP is the access point in the wireless network. Its function is similar to the switch in the Wired Network, when an AP exists in the wireless network, the coverage of the wireless network will be doubled from the original one, and the wireless network devices supported by the wireless network can also be added, 2. for wireless networks with AP access points, you must first configure the AP and its IP address, and then set up a wireless device to establish a connection with the Wireless AP and add it to the corresponding AP network, you can also access the existing LAN through the Ethernet interface on the AP to achieve wireless and wired integration.
Three, Ad-Hoc1, in the early Home Networking, two computers installed with wireless network card wireless interconnection, one of the computer connected to the external network can share broadband, this is Ad-Hoc, point-to-point mode. 2. The Ad-Hoc structure is a peer-to-peer network structure that eliminates the need for Wireless AP construction. As long as the computers with wireless NICs installed can achieve wireless interconnection with each other, the principle is that a computer in the network establishes a point-to-point connection equivalent to a virtual AP, and other computers can directly use this point-to-point connection for network interconnection and sharing. 3. Generally, the transmission distance of a wireless network card in an indoor environment is about 40 M. When the valid transmission distance is exceeded, communication between the two networks is not possible, the shared bandwidth is also greatly affected. Therefore, this mode is only suitable for some simple or temporary wireless networking requirements.