Joint TL-WA832RE Router Amplification wireless signal not successful how to do

the method of solving the TL-WA832RE amplification Radio signal unsuccessful

If you set the Tp-link Tl-wa832re extended (amplified) wireless signal, the LEDs on the tl-wa832re are red and illuminated steady, indicating that the tl-wa832re extension (amplified) wireless signal is unsuccessful, please install the method described below for troubleshooting.

Tp-link Tl-wa832re Extended (zoom) device

First, check the wireless settings on the main router

Please log in to the Setup interface of the main router (the router that is amplified by the wireless signal), and then check and set the following:

1, check the wireless signal settings

Click on the "Wireless Settings"--> "Basic Settings"--> confirm the SSID number, verify that the wireless function and SSID broadcast is turned on.

Check the wireless signal name settings on the main router

2, check the wireless password settings

Click on "Wireless Settings"--> "Wireless security Settings"--> View the PSK password (wireless password), TL-WA832RE extended signal when the password must be filled in with the same.

Check the wireless signal password settings on the main router

3, turn off "Wireless MAC address filtering" function

In the wireless router settings interface, click "Wireless Settings"--> "Wireless MAC address filter"--> "MAC address filtering function" Click: Turn off the filter, detailed settings as shown in the following figure

Check to see if wireless MAC address filtering is turned off on the primary router

4, turn off the "Internet control" function

Click on the "Internet control"--> do not check "open the Internet Control"--> Click "Save"

Check to see if the "Internet Control" feature is turned off on the primary router

5. Turn off the Parental Controls feature

Click "Parental Control"--> "Parental Control" and then choose:--> click "Save" without enabling

Check that the Parental Controls feature is turned off on the primary router

Second, reset the tl-wa832re and reset

If you check the primary router's first-pass setting to determine that there is no problem, but the wireless signal for the tl-wa832re extension (enlarged) primary router still fails, reset the tl-wa832re and then reset the tl-wa832re extension information.

Reset method: In the case of tl-wa832re power supply, using toothpicks or other objects, hold down the tl-wa832re on the reset hole 5-10 seconds, when the system status indicator Flash 5, release the reset button.

Third, reduce the distance between the tl-wa832re and the main router

After you follow the above method, confirm that the Extender and primary AP settings are normal, but still expand unsuccessfully. You can try to reduce the distance between the Extender and the primary AP, which may cause the extension to be unsuccessful if the distance is too long and the signal strength is too weak.