Telephone Line Access users (please prepare 2 cable)
The phone line (the relatively thin one) to pick up the cat lines (the relatively small mouth), the cat out of a network cable to connect the router's WAN, and then find a network cable, a computer, a router to connect the LAN port, wiring mode as shown:
network cable users directly into the household (please prepare 2 cable)
Directly to the household network cable connected to the WAN port of the router, and then find a network cable, a computer, a router to connect the LAN port, wiring mode as shown below:
Note : After the connection completes, check that the router LEDs are normal
Set the local connection IP address on your computer to " get IP address automatically "
1, left click on the desktop " start " → " control Panel " → " Network and Sharing center " → " Change network adapter ":
2. Right-click " Local Area Connection " and select " Properties ":
3. Double-clickInternet Protocol (TCP/IP):
4. Select " automatically obtain IP address " and " automatically obtain DNS server address ", click " OK ". Go back to the previous screen and click OK .
1. Double-click the mouse to open the browser, in the browser input:192.168.1.1 Press ENTER, in the Jump page Enter account guest, password guest, click " OK ”
2, into the routing interface settings, in the page of the network access type has 3 types of access to choose " static IP", " dynamic IP", "PPPoE".
static IP (with fixed IP, subnet mask, gateway, DNS broadband users) dial-up Internet users , You can click " static IP" input computer network fixed IP address, subnet mask, default gateway, preferred DNS server , and then set the wireless SSID number and password, OK, refer to the following setup steps:
"Dynamic IP" (a network from another router, such as a company, a community, or a broadband user with a neighbor) , chooses " dynamic IP" on the page's network access type. Set the wireless SSID number and password, " ok ", refer to the following setup steps:
Broadband Connection Program dial-up Internet access of users, in the network access type of the page, select PPPoE ", enter the broadband account number and password, and then set the wireless SSID number and password," Determine ", you can refer to the following setup steps:
1, left click on the desktop " start " → " control Panel " → " Network and Sharing center " → " Change network adapter ":
2. Right click on " Wireless network Connection ", click Select " connection/Disconnect (O)":
3. Wireless connection appears in the lower right corner of the desktop. Select the wireless network name for the router (default Netcore), double-click, and then enter the account number and password.
4, to see whether the wireless network connection, the success of the connection can be online.
Light |
Name |
Normal state |
SYS |
System Status LEDs |
often flashing or flashing |
WAN |
WAN Status Indicator |
often flashing or flashing |
Wlan |
WLAN Status Indicator |
often flashing or flashing |
|
interface to the computer corresponding to the LED flashing or flashing |