Linux Commands-Network command: Setup

Setup enters the interface for setting up network information

Select "Network Configuration" to enter set up network information

Select "Device Configuration" to configure IP address, display network card information

, select "Eth0" to enter the setup eth0 NIC information interface

Select "OK" button to return to the Display network card information interface

Select the "Save" button to go back to setting up the network information interface

Select the "Save and Exit" button to go back to Setup's first interface (ie: Network information interface)

Select the "Exit" button to end the operation of setting the NIC information.

Service Network Restart after you change the network information, be sure to remember to perform the command to restart the network service

Linux Commands-Network command: Setup