Linux Network card configuration file

Through the investigation of information and work in the summary:

Device= "Eth1"

Nic Name
Nm_controlled= "Yes"

Network Mamager parameters, whether it can be managed by Nnetwork Manager

hwaddr=                                        

MAC address
Type=ethernet

Type

Prefix=24

Subnet mask 24-bit

Defroute=yes

Is the default route, whether to set this ETH as the

onboot=yes                                

     set to Yes, power on automatically enable network connection
ipaddr=                                          

IP Address
Bootproto=none

Set to none disable DHCP, set static IP address to static, set DHCP on for DHCP service
netmask=255.255.255.0

Subnet mask
dns1=8.8.8.8

First DNS server

Broadcast

Broadcasting

Uuid

Uniquely identifies

Type=ethernet

     network type is: ETHERNET
gateway=                                     

     Set the gateway
dns2=8.8.4.4 #                               

     a second DNS server

Prohibit IPV6
Userctl=no

Whether to allow non-root users to control the device, set to No, can only be changed with the root user
Name= "System eth1"

This is the name of a network connection.

Master=bond1

Specify the name of the master

SLAVE

Specifies that the interface is a component of a bonded interface.

NETWORK

Network address

Arpcheck=yes
Detection

Peerdns

Whether DHCP is allowed to obtain DNS overrides for local DNS

Peerroutes

Whether to obtain routing table entries from the DHCP server for information that defines the default gateway for the interface

Ipv6init

Whether the IPv6 interface is enabled.

Ipv4_failure_fatal=yes

Disable device if IPv4 configuration fails

Ipv6_failure_fatal=yes

Disable device if IPv6 configuration fails

This article is from the Linux OPS blog, so be sure to keep this source http://xtbao.blog.51cto.com/7482722/1892313

Linux Network card configuration file