Linux network sharing settings in VMware in Windows 7

1. Wireless Network Sharing: if an error message is displayed, enable the Service and start the windowsfirewall service. Note: After selecting share here, the system will prompt you to set the vmnet1 IPaddress to 192.168.137.1, you can use the default one without modifying it. 2. Set the linux network in the vm to Host-only mode. 3. Set

1. Wireless Network Sharing:

If an error occurs during sharing, open the service and start the windows firewall Service.

NOTE: If share is selected, the system promptsVmnet1OfIpSet192.168.137.1You can use the default one without modifying it.

2. Set the linux network in the vm to Host-only.

3. Set linux ip Configuration:

Note: The IP address CIDR block here must be the same as that of vmnet1 and not equal to 1, for example, 192.168.137.3 (3 ~ 254). The default GATWAY is the IP address of vmnet1.

Set the DNS to the common DNS in your region. I am using the DNS service in Guangdong.

OK, you can access the Internet...

This setting can also be used to connect Windows 7 and linux

Note: I did not test the wired network because I am using wireless Internet access and do not have the conditions for wired Internet access. Therefore, there is no specific experiment steps. I have used a limited number of methods before and it is very simple, as longOfIpSet as allowed in the LANIPYou can. The specific test will be performed when the environment is available.