Linux Ubuntu touchpad is easy to use

If you have installed the Ubuntu release, your X configuration file (xorg. conf) the relevant driver has been set in it, which is the default setting. You only need to add some relevant parameters and it will be OK. The following is the default Ubuntu touchpad configuration: Section "InputDevice" Identifier "SynapticsTouchpad" Driver "synaptics" Option "SendCoreEvent

If you have installed the Ubuntu release, your X configuration file (xorg. conf) the relevant driver has been set in it, which is the default setting. You only need to add some relevant parameters and it will be OK. The following is the default touchpad configuration for Ubuntu:

Section "InputDevice"
Identifier "Synaptics Touchpad"
Driver "synaptics"
Option "SendCoreEvents" "true"
Option "Device" "/dev/psaux"
Option "Protocol" "auto-dev"
Option "HorizScrollDelta" "0"
EndSection

Let's make the subsequent changes take effect without restarting X. in the above section, add:

Option "SHMConfig" "on"

Then restart X, so that you can dynamically use the synclient command to modify the parameters of your touchpad. Of course, there are also Gui programs, such as qsynaptics. We recommend that you use synclient, which is the most powerful command line, right. For example, synclient Var1 = value1 Var2 = value2 ....

Because the resolutions of various monitors are different, the default settings may make you think it is too slow to move the pointer using the touchpad. let's correct this:

Option "minspeed"" 0.9"
Option "maxspeed"" 1.5"
Option "AccelFactor" "0.0750"

This is my setting. My resolution is 1920x1200, so you can modify it as needed. Generally, MinSpeed 0.5, MaxSpeed 0.9, and AccelFactor 0.0350 are OK.
There are only two Pads under the touchpad on many computers. What should I do if there is no middle key? OK:

Option "RBCornerButton" "3"

Now you can click the upper-right corner of your touchpad, which is the upper-right corner. In general, right-click the bottom right corner of the touchpad, middle-click in the upper right corner, and up and down scroll at the right edge, and left and right scroll at the bottom edge. These are the default settings, you can use synclient-l to view the default settings on your machine.

If some of the preceding settings related to edges and corners do not work, the default edge settings are incorrect. You can set LeftEdge, RightEdge, TopEdge, and BottomEdge to suit your needs.

If your touchpad supports multiple points, you can set it to scroll with two fingers like a MacBook.

Finally, we recommend a small program to simulate and test the behavior of your input device, xev.

There are also a lot of fine-tuned parameters, man synaptics to study it.