Linux under the hard drive to install Windows system.

Note: This method will damage the Linux system after installation, and the method is suitable for completely eliminating the need for a Linux system.

This method was successfully tested in Ubuntu 14.04,centos 6.5,debian 8.

The installation method is to boot the Windows PE image through GRUB2 and then install Windows through PE.

Specific steps:

2. Prepare the PE image. The file is placed in the root directory (any other directory may be available, but you need to specify a specific location for subsequent booting).
4. The syslinux is installed to obtain the Memdisk file.
   

    Install syslinux #其他发行版的安装方法都差不多, copy the/usr/lib/syslinux/memdisk to the root directory after installation

6. Reboot the system into the GRUB2 boot command line and enter the following command.
   

   1 ls     #列出所有的硬盘分区 2ls (hd0,msdos1)/    #查看分区下的文件, which is to find the partition position where the PE is located 3 Set root=(HD0,MSDOS1)    #设置分区为根分区 4 linux16/memdisk ISO raw    #加载memdisk for use with PE boot.  5 initrd16/winpe.iso            #加载PE镜像, this step takes a few seconds to execute.  6 boot    #启动PE

8. If it goes well, it will enter the PE. In PE, if the PE band network, you can download the Windows Ghost or the original image installation system remotely. PE I recommend a download tool, Aria2.exe, the advantage is that the memory is very small, and then support a lot of download protocol.

Linux under the hard drive to install Windows system.