Linux View network card number and speed

 # lspci | grep Ethernet
03:00.0 Ethernet controller: Broadcom Corporation NetXtreme II BCM5708 Gigabit Ethernet (rev 12)

   
    # DMESG |grep Span style= "color: #990000;" >eth0 
     divert:allocating divert_blk for eth0 
 Eth0: Span style= "font-weight:bold; Color: #000099; " >realtek RTL8139 at 0xd800, 00:80:48:34:c2:84, irq 9   /span> 
  eth0:identified 8139 chip type ' rtl-8100b/8139d ' 
 divert:freeing Divert_blk for eth0 
 divert:allocating divert_blk for eth0 
 Eth0:realtek RTL8139 at 0xd800, 00:90:44:34:a5:33, IRQ 9 
 eth0:identified 8139 chip type ' rtl-8100b/8139d ' 
 eth0: link Up, 100mbps,  Full-duplex, LPA 0x41e1 
 Eth0:no IPv6 routers present 
 ... 
 
     

mii-tool -v eth0

negotiated 100baseTx-FD, link ok
product info: vendor 00:00:00, model 0 rev 0
basic mode:   autonegotiation enabled
basic status: autonegotiation complete, link ok
capabilities: 100baseTx-FD 100baseTx-HD 10baseT-FD
 10baseT-HD
...

ethtool eth0

Settings for eth0:
 Supported ports: [ TP MII ]
 Supported link modes:   10baseT/Half 10baseT/Full
                         100baseT/Half 100baseT/Full
 Supports auto-negotiation: Yes
 Advertised link modes:  10baseT/Half 10baseT/Full
                         100baseT/Half 100baseT/Full
 Advertised auto-negotiation: Yes
 Speed: 100Mb/s
 Duplex: Full
 Port: MII
 PHYAD: 32
 Transceiver: internal
 Auto-negotiation: on
 Supports Wake-on: pumbg
 Wake-on: p
 Current message level: 0x00000007 (7)
 Link detected: yes

Linux View network card number and speed