Linux Installation Application Tip graphical installers is not supported by the Vmtechnote (troubleshooting)
Problem (Abstract)
Attempts to install IBM Security AppScan Source on Linux results in the message "graphical installers is not supported by The VM.
Symptom
When installing AppScan Source Edition on Linux, you receive the following message:
graphical installers is not supported by the VM
Attempts to continue with the installation on Console mode fail with the following error because the AppScan Source instal Ler does not support Console mode installs:
Installer User Interface Mode not supported
Cause
This problem can occur for the following reasons:
- The file /usr/lib/libstdc++.so.5.0.7 or later is not installed on the system.
- The $DISPLAY environment variable is not properly set.
- The necessary X Windows libraries for running the GUI installer is not available.
Resolving the problem
The solutions below relate to the causes above:
- Install libstdc++.so.5.0.7 or later.
See the AppScan Source Edition release Notes, which is included in the Docs directory of the installation files for infor Mation on installing this library.
- Set your $DISPLAY environment variable to a valid DISPLAY.
If you is on a 64-bit RHEL machine, you'll also need to do the following:
- Install the missing 32-bit dependencies via the following command:
yum-y install libx11.i686 libxtst.i686 gtk2.i686 glibc.i686 libgcc.i686 webkitgtk.i686
- Run the installation process with the system ' s default 64-bit JRE:
./setup.bin Lax_vm/usr/bin/java
If after performing the steps above the issue still persist, this could be variation of the issue where the issue is the Uni Nstaller is unable to open the display. To validate this issue is due to lack of access to the display, launch the installer without sudo. If the installer displays as the user this is an access issue to the display. If VNC is used to connect to the server and then the following command would need to be ran:
Xhost + localhost
If physically present at the server or if SSH is used to connect to the server with the following command:
Sudo-e./setup.bin Lax_vm/usr/bin/java
Tip: Restart the system after executing the command
Linux virtual machine installation application Tip Graphical installers is not supported by the VM