The focus of beam production is to pay attention to the level of good light, the production of the first from the bottom of the dark light began to slowly render, the brightness of the beam by layer, so that the beam to make clear, very penetrating.
Final effect
< small map view big picture >
1, before making analysis of the composition of good light, roughly divided into three parts to complete, first to make the right half, the effect of the need to complete the following figure.
< map 1>
2, a new group, a new layer in the group, first to the bedding of the beam. Use a pen to check out the selections shown in the following illustration, fill in the dark red, and then reduce the opacity of the layer appropriately.
< map 2>
3, create a new layer, the above method to check out a slightly thin beam, the same fill dark red, and then appropriately reduce the opacity of the layer. After you remove the selection, add the layer mask, and use a black brush to apply a little transparency to the ends.
< map 3>
4, create a new layer, in order in the top of the beam edge to check out the selection shown in the following figure, filled with dark red. After you deselect the selection, add a layer mask and apply a black brush to both ends.
< map 4>
5, create a new layer, with a pen in the current edge of the beam to tick a thin beam, fill a slightly bright red, make the edge of the highlight, the local need to adjust the transition with the mask.
< map 5> categories:
- PS Getting Started Tutorial