Meizu MX3\MX2 in MTP mode to recover mobile phone data deleted by mistake tutorial

Yesterday to help a roommate's Meizu MX3 upgrade system, the results accidentally deleted his phone photos. But since the FlyMe upgrade to 3, the previous U disk mode has been changed to MTP mode, so that after connecting the computer can not be used on the computer data recovery software to recover data, because there is no detection of the disk ...

Then with incomparable guilty mood, I found a lot of tutorials on the Internet, the results of no one can use ... Later, combined with online information, after some toss, finally kung fu to toss out a practical method, in my second sister and roommate's three sister on the pro-test available. Now selflessly share to kerosene!!!

Start by stating two points before you begin:

One, the data recovery is a probabilistic operation, can not guarantee a certain recovery, in theory, the shorter the deletion time, the less mobile phone use after deletion, the more likely the data can recover, cut this operation only applies to the deleted files, the format of the file is not estimated.

Second, in the process of recovery, try not to put the program back in the background, or there will be a certain probability of recovery software crashes and naught, but also to start again, this point to remember.
Ok,now Let S do it!

1, to get the root privileges of the phone, there is "do not want root obsessive-compulsive disorder" kerosene can be restored after the data in the system again (in this once again praise the Meizu "Allow root" policy).

2, install the two software in the accessory.

flyme system permissions software: http://d.meizuhui.com/20140907/Flyme system permissions. APK

Data Recovery software: http://d.meizuhui.com/20140907/data recovery. APK

3, open "FlyMe system Permissions", select "General Installation" and then "Allow" and then "OK".

4, go back to the desktop, open with another software, is the plus the shovel that, next into the play.

5, select "Always Remember to select"-"Allow"

6, refresh the list, and then select the storage, is the largest capacity of that, my phone is 16G, available 11.77G, choose this, and then click "Sweep surface Equipment".

7, in the Pop-up window select the type of data to recover, take the photo as an example, the first JPG hook, of course, you can choose More, then click OK.

8, the next is waiting ... 0到100% ... The whole process is a few minutes long and half an hour is possible ... Calm......

During the recovery process, you can click on the file in the list to preview the photos, such as:

9, after the scan is over, tick the data you want to recover, or tick the top box to select All files, and then delete them after you have restored them. Then click "Save to local" in the lower right corner.
Of course, if not yet to 100%, but you can see through the preview of the photos you want to recover has been able to find in the list, you could directly point to stop the scan, and then the data to be recovered check on it, this can save some time, if not rest assured, or honestly wait for the scan to end it.

10, in the next pop-up window select where you want to restore the file to, for example, I was restored to the download folder, click OK.

11, then after a small recovery, your selected data will be restored to the selected folder ....

12, after the completion of the desktop, go to the document download folder, you can find the recovered files. Of course, the file name has not been deleted at the time of the file name, but anyway, the files have been found back!

All the above text and pictures from Meizu forum Suan Tao Remote tutorials, thank you very much. This site only do reprint, if there is discomfort, please contact the webmaster Delete.

Original Address: http://bbs.meizu.cn/thread-5021842-1-1.html

Meizu MX3\MX2 in MTP mode to recover mobile phone data deleted by mistake tutorial