Mercury Mercury how to set bandwidth control?

First, Application Introduction

Network bandwidth resources are limited, some computer high-speed download, online video occupy a lot of bandwidth, resulting in other computers appear "slow Internet, network card" phenomenon. The speed limit function can limit the maximum up and down line speed of the computer, thus ensuring the reasonable utilization of the whole network bandwidth resources.

This article introduces the application and setting method of the speed limit function.

Second, set up the method

1 , access to the Router management interface

The computer uses the network cable to connect the router's LAN port or uses the wireless connection router's wireless signal, opens the browser, empties the address bar, enters melogin.cn (or 192.168.1.1), fills in the management password, the login management interface.

Note : The admin password is a 6-15-bit password set when you first log on to the router, and if you have forgotten, reset the router and set it up again.

2 , set the host device speed

① found the managed host

After entering the router management interface, click on the Common settings > Connection Device Management > Host Equipment , find the relevant items of the desktop (can be determined through the IP address of the terminal equipment), The following figure:

② Set Desktop speed

Click, modify terminal name for common name, easy to manage. Then click on and, set the maximum number of downlink speeds respectively.

Note : The speed limit is for the device's MAC address, the device does not need a fixed IP address, the device changes the IP address does not cause the speed limit does not take effect.

③ Set Mobile speed

Use the same method to limit the mobile phone's speed up and down, as shown in the following figure:

3 , set the speed of guest equipment

Click on the Advanced Settings > Wireless Settings > Visitors Network in the admin interface to set the maximum speed of the top and bottom rows of the guest network, click Save . The following figure:

Note : The maximum upload speed and maximum download speed is the speed at which all terminal sharing is connected to the guest network.

The real-time rate of each guest device can be viewed in common settings > Connection Device Management > Visitor Devices , as shown below:

At this point, the speed limit setting is complete.

Iii. Questions and Answers

You may be concerned about the following issues:

How much does the maximum speed limit fit?

A : the rate limit is related to your total bandwidth and the application of restricted terminals, such as your broadband is 20Mbps, then a terminal maximum 8Mbps is also reasonable, but if the total bandwidth is only 8Mbps, you need to reconsider. So, we provide a reference rate (1byte=8bit, such as 20KBps or 160Kbps), which you can set according to your requirements:

Application	Uplink requirements	downlink Requirements
QQ , micro-letters, etc.	20KBps	50KBps
Browse Web page	20KBps	100KBps
Online games	50KBps	150KBps
Video Download class	50KBps	300KBps

Note : The above recommendation is only the rate required to ensure smooth use.

terminal changed. IP is the address still under control?

A : the speed control mechanism of the router is through the terminal MAC address for the Internet speed control, the replacement of IP address will still be controlled. It is recommended that you name all terminals so that they are easy to manage.