Modify WINXP pro installation interface, modify WINXP pro boot screen, and modify WINXP pro logon screen

1. Modify WINXP pro installation Interface
----------------------------
Installation interface-that is, after installing and copying the system file, restart the installation interface. This interface takes a long time and is worth changing

After copying the WINXP pro installation file to the hard disk, click the "i386" directory to find "winntbbu. DL _" and copy it to a local location.

And then use WinRAR to open winntbbu. DL _ and drag out a system file winntbbu. dll. (You can also use exescopr to modify resources, but the receiver can

Figure kb or less.

(1) Use resourcehacker to open winntbbu. dll, find 103 (English version) in 1033, and delete it. Replace 2052 (Chinese version) first

), And then create a resource. The resource points to the bitmap. The resource name is 103, the resource language is 1033, and the resource is replaced successfully.

Put them on, and the remaining two bitmaps are 153. Just replace them with the same method !!!

(2) After modifying the winntbbu. dll file, you can generate the winntbbu. DL _ file.

Winntbbu. dll on disk
In the root directory (such as C :), go to the DOS of WINXP, point the cursor to the drive C, and run the makecab command:

"Makecab winntbbu. dll winntbbu. DL _"
You can generate a winntbbu. DL _ file on drive C !!!!

(3) errors may occur during the replacement process. Generally, they are not caused by steps or the picture is not standard. Try more. In addition, repair

After modification, the file may be relatively large or different from that of the original Microsoft, but it will not be wrong during installation.

(4) If the system has been installed, find the winntbbu. dll file in the system's Windows system32. After the system is installed, it is not deleted, but decompressed and placed here.



========================================================== ========================================================== ========================
Ii. Modify WINXP pro boot Screen
----------------------------

The boot screen is the scroll screen that appears when the machine is turned on after the WINXP pro system is installed. This screen mainly modifies ntoskrnl. ex _

This file is also searched for "ntoskrnl. ex _" under "i386", found and copied to a place, opened with WinRAR, dragged out

The file ntoskrnl.exe; opened with resourcehacker, the bitmap is inside: 1, 2 ,...... 8, 9, and 1000; modify a single image;


After the modification, copy ntoskrnl.exe to the C: disk, open "doscommand mode", point to C:, and run:

"Makecab ntoskrnl.exe ntoskrnl. ex _"
You can generate a modified ntoskrnl. ex _ on drive C. Successful !!

Note: The generated file may be large, but generally it will not cause any problems. Just put the file under i386.
If the WINXP prosystem has been installed, you can put the modified ntoskrnl.exe under C: Windows system32 to replace the original

.

========================================================== ========================================================== ========================
3. Modify WINXP pro logon screen
----------------------------

Logon interface-that is, the previous interface of "welcome to use". This interface is displayed if you set a password to log on. This interface can be modified

You can modify the logonui. ex _ file. You can find it in "i386". First open it with WinRAR and drag the file

Logonui.exe;

Use resourcehackerto open logonui.exe. modify it...


If the system has been installed, the logonui.exe file is installed under Windows system32, and modification can achieve the expected results.

 

 

Original text transferred from:Http://wdx4488.blog.163.com/blog/static/1079147620061170955135/