Multiple host IP address modification methods for HP minicomputers

Method 1 for modifying host IP addresses of HP minicomputers. set_parmshostname2.set_parmsaddress3. modify the/etc/hosts file. note: The above method has actually modified/etc/rc. config. d/netconf. Method 2. vi/ etc/rc. config. d/ne... method 1 for modifying host IP addresses of HP minicomputers. set_parms hostname 2. set_parms address 3. modify the/etc/hosts file. note: The above method has actually modified/etc/rc. config. d/netconf. Method 2 after the machine is restarted. vi/etc/rc. config. d/netconf 2. manually modify the/etc/hosts file. note: Method 3: (reboot is not required.) 1. use method 1 or method 2 to modify the configuration file. manually modify the/etc/hosts file 3. executive Line (recommended on the console)/sbin/init. d/net stop/sbin/init. d/net. init stop/sbin/init. d/net. init start/sbin/init. d/net start # cat/etc/rc. config. d/netconf # netconf: configuration values for core networking subsystems # @ (#) B .11.11 _ LR $ Revision: 1.6.119.6 $ Date: 97/09/10 15:56:01 $ HOSTNAME = "hp4440a" OPERATING_SYSTEM = HP-UX LOOPBACK_ADDRESS = 127.0.0.1 # Modify the host name and restart the host. # For each additional network interfaces, add a set of variable assignments # like the ones below, changing the index to "[1]", "[2]" et cements. # IMPORTANT: for 9. x-to-10.0 transition, do not put blank lines between # the next set of statements INTERFACE_NAME [0] = lan1 #0 indicates this is the first Nic parameter, and so on. IP_ADDRESS [0] = 10.77.220.115 SUBNET_MASK [0] = 255.255.248.0 ------------- network adapter BROADCAST_ADDRESS [0] = "" INTERFACE_STATE [0] = "" DHCP_ENABLE [0] = 0 # The NODENAME variable (limited to 8 chars) will be used to set the # UUCP name (uname-S), since HOSTNAME is longer than 8 chars. NODENAME = hp4440a ROUTE_GATEWAY [0] = 10.77.220.1 ---------- default route ROUTE_COUNT [0] = 1 ROUTE_DESTINATION [0] = default