New configuration command of Huawei Router

Today, we will introduce the differences between the new setting commands of Huawei routers and those of the old ones, so that you can refer to those who use Huawei routers for the first time. I. Level 1: In the past, the USER command level ing function only used level 0, 1, and 15. Basically, most of the commands were level 15, after entering the privileged mode, you can use all the commands of the system.
After logging on, the user enters the normal user mode:
Quidway> enable 15 enters the privileged mode, and the level switches to 15; Quidway # configure terminal enters the global configuration mode; Quidway (config) # in the global mode; www.2cto.com Quidway (config) # interface Ethernet 6/0/0 to enter the interface mode; Quidway (config-if-Ethernet6/0/0) # In interface mode; Quidway (config) # router bgp 1 to enter the routing configuration mode; quidway (config-router-bgp) # in routing configuration mode.
2. Currently, commands are divided into four levels. Users of different levels can only log on with the same or lower-level command users without changing the level. After logging on to the user, go to the User View:
<Quidway> super 3 switches from user level to 3 without changing the view; <Quidway> in user view; <Quidway> system-view enters system view; [Quidway] in system view; [Quidway] interface Ethernet 6/0/0 go to interface view; [Quidway-Ethernet6/0/0] Go to interface view; [Quidway] bgp 1 go to bgp view; www.2cto.com [Quidway-bgp] is in the BGP view.
Ii. Unified User View 1. Configuration level: Business configuration commands, including routing and network-level commands, which are used to provide users with direct network services. 2. Visit level: USER commands (PING and TRACERT) of the network diagnostic tool, commands for accessing external devices from the current device, and other commands hidden. Commands of this level cannot be saved in the configuration file. 3. Management Level: commands of the system support module related to the basic operation of the system. These commands provide support for the business, including: file System, FTP, TFTP, XMODEM download, configuration file switch command, power control command, backup board control command, user management command, level setting command, system internal parameter setting command. 4. Monitoring level: used for system maintenance and service fault diagnosis, including the DISPLAY command and DEBUGGING command, which cannot be saved in the configuration file.