No line is set by relay and local fixed IP

Recently to use nat123 software, using the premise is fixed local IP, so I use this router to relay a primary router, and build a LAN. Router A uses the Tp-link router, and Router B uses the Bl-link router. Take the dial-up access network as an example, let me share my configuration process below.

Step one, no line by relay

Router a(tp-link)

Router a(tp-link) as the primary router, according to the instructions to complete the configuration, no special requirements.

Check the DHCP service to make sure it is enabled.

Configure the information to be retained (this information is used during router B configuration):

Step One figure 2016-201

Step one figure 2016-202

Step two, fixed the local computer IP

Connect the LAN port of Router a(tp-link) with one end of the network cable and one end to the local computer

Open Open Network and Sharing Center, open change adapter settings,right -click Local Area Connection, select Properties, and thendouble-click Internet Protocol version 4 (TCP/IPV4), select Obtain the IP address automatically and obtain the DNS server address automatically.

Step two figure 2016-203

Left "Start", enter "cmd" click Enter-------------------"ipconfig/all" and save the information.

Step two figure 2016-204

Step three, configure wireless router B (lb-link)

Connect Router a(tp-link), router B, and the local computer with a network cable as follows.

Step three Figure 2016-205

Router B (lb-link)

go to the management page of Router B and configure it in the same way as router a(tp-link) .

Wireless settings. The guarantee is consistent with the information in step one, figure 2016-201, and step one, figure 2016-201.

Local Connection Physical Address
IP Address
Subnet mask
Default Gateway
DNS Server

Wireless relay settings.

In router B, in the relay setting, select Router A's wireless signal to set.

->wan Port settings. Connection type: Dynamic IP

->lan Port settings. Default

->DHCP Services. Enable

Step four, improve the work

Local computer

Set the local IP address. Use the address of "Step two figure 2016-204".

Setup is complete.

==============================================================

+++++++++++++++++++++++++++++++++++++++++

+++++++~~~~~~~~~~~~~~~~~~~~~~~~~~~~++++++

+++++++ I hope to help you, big God don't squirt  ++++++

+++++++~~~~~~~~~~~~~~~~~~~~~~~~~~~~++++++

+++++++++++++++++++++++++++++++++++++++++

================================================================

No line is set by relay and local fixed IP