NTP time synchronization server configuration instance (CISCO 7200 route)

This article describes in detail how to configure the NTP time synchronization server, and takes CISCO 7200 as an example. I hope this article will help you.

For the purpose of network management, we set up netflow to monitor traffic and obtain detailed access records for Intranet users to access the Internet. Such records can be accurate to seconds, the premise is that the time of the monitored vro or vswitch and other network devices must be absolutely synchronized with the time of the server where the monitoring log is located (either win or solaris.
 
For Windows system time synchronization, you can click the time in the lower-right corner, select Internet time, and set the time synchronization server. The synchronization method between win2000 and 2003 is slightly more complex. The detailed process is described below.
 
It is also very simple to synchronize cisco routers or switches. You only need to know about NTP:
 
NTP: Network Time Protocol
 
Some Cisco devices do not have a clock. Once restarted, the clock is reset to the initial time, which is why we use NTP. NTP can be used to synchronize with the first-and second-level clock sources on the Internet. We can query http://www.eecis.udel.edu /~ Mills/ntp/clock1a.html to find the clock source closest to its own location.
 
Configuration method:
// Router 7206
Conf t
Ntp source FastEthernet0/1 // specify the update source address to overwrite the configuration in the ntp server
Ntp update-calendar // If a device has a hardware clock, update the hardware clock at the same time.
Ntp server 202.155.248.218 source FastEthernet0/1 // specify the update Destination Address, Hong Kong, and the update source interface to f0/1.
 
Int f0/1
Ntp enable
 
At this time, you should have obtained the time, but note that the time zone is correct. The default value is Greenwich Mean Time. to change it to Beijing time, the following steps are essential.
 
Clock timezone BeiJing 8 // the last number 8, representing the + 8 time zone.
 
Verification Method:
Show ntp status
Show ntp associate
 
Written by cracker
Cuijian.vip@gmail.com
Http://blog.sina.com.cn/cisco
 
Once the association is established, we can synchronize the clock of the win log monitoring server with the CISCO router to ensure absolute synchronization of the clock, ensure that our network access logs are accurate to the unit of seconds.
 
Win2000 and 2003 synchronization methods are not as simple as XP
Execute in DOS status:
Net time/setsntp: 202.155.248.218 // Hong Kong
W32tm-once can be used for NTP synchronization immediately
 
In addition, here we will explain the two NTP usage methods:
Ntp server the local device updates its own time through the remote clock source, one-way.
Ntp peer the device can both receive clock synchronization and provide a two-way clock for the remote device.