Oracle 10g installation problem: Microsoft loopback adapter Configuration

Problem description:
When installing Oracle 10 Gb, the first condition detection will appear
"Checking Network Configuration Requirements... the check is complete. The overall result of this check is: not executed <
Proposal: Oracle supports installation on a system with IP addresses allocated by DHCP. Before installation, you must configure the Microsoft loopback adapter as the primary network adapter of the system. For more information about installing software on a system with DHCP configured, see the installation guide ."

Solution:
Before installing Oracle 10 Gb, the system will check whether some of the prerequisites for installation are met. It will often prompt you to configure the Microsoft loopback adapter as the primary network adapter of the system.

If you do not configure this configuration and you do not want the installation process to fail, the process is as follows:
Go to control panel/Add hardware. In the wizard, select "Yes, connected to this hardware"> "network adapter"> "Microsoft loopback adapter". The configuration is complete, you will find that a new "Local Connection" is created, using this fake "Microsoft loopback adapter" (because the hardware is not connected at all, just lie to Oracle ). Set the IP address of the local connection (for example, 192.168.0.8 ). Now let's go back and let Oracle check again. It should have passed.