Are you often unable to access the Internet without a campus network recharge card? It doesn't matter. Today we will teach you how to use a roommate's network to access the Internet through ad hoc. The premise is that both of you are laptops. Therefore, this is a light and temporary networking method, because it does not need to use any other auxiliary equipment, just two laptops. Let the wireless router go to hell!
Ad-hoc is different from wireless Internet access. It does not require an AP (access point ). It is a point-to-point wireless network application mode, applicable only to 2 (point-to-point !) Network Connection between devices. (In essence, a computer acts as a virtual AP. It's okay if you don't understand it .)
Today, the prototype of this solution is university dormitory Internet access, but it is also very suitable for the establishment of a home wireless LAN, it allows a computer to share the bandwidth of another computer that has connected to the Internet.
Well, let's not talk about it. Let's get started.
I. Prerequisites
Computer A: a computer with a network, with a wired network card that can access the network through mentohust (similar to ruijie's dial-up software), and a wireless network card. It is the good guy who provides bandwidth.
Computer B: No network-connected computer, no network fee, so mentohust dial-up fails, but has a wireless network card. It is the Child paper that asks for support.
2. networked computer
1. Open Network and sharing center in Control Panel, click local connection, and set sharing in properties ].
2. Select [allow other network users to connect to the computer through the Internet connection] and [allow other network users to control or disable shared Internet connections], and then [OK ].
3. After the local connection is shared, go back to the network and Sharing Center page and click set new connection or network ].
4. Select set wireless temporary network ].
5. Click Next twice and enter the network name, type, and security key on the following page.
6. After the related information is entered, the new temporary network connection is set. Hey, now the computer with a network is configured.
3. netless computer B
After the wireless network card is enabled for a computer without a network connection, you can find the wireless network named HSCC, connect to the computer, and enter the set key. Make sure that the IP address in the connection properties is automatically obtained. You should be able to access the Internet!
It's easy to say. But I never knew it before, so it's amazing. I hope you can try this method again.