(Original signature) How does one determine "timestamp value does not match: Image on board is older than expected? (SOC) (nioii

Abstract
This is a natural interest that beginners often encounter when they are learning the niosio II. This article proposes a solution.

Introduction
Use environment: US us II 8.0 + nioii eds 8.0

The most common principal interest of a beginner of niosii is "leaving target processor paused". I am at (original principal) how can we determine the valid parameter information of the "leaving target processor paused" of the niosii? (IC design) (Quartus II) how can we determine the valid parameter information (ii) of the "leaving target processor paused" section of niosii )? (SOC) (nano II) (DE2-70) has been discussing the method of the previous solution, another common attention: 'timestamp value does not match: Image on board is older than expected ', which is the important point of this article.

Response Message

At this time, no matter how you use Quartus II to re-renew the project, or use niosii eds to clean the project or re-renew the project. Simply put, it isYou have completed *. Sof finished !!

Why does it happen when *. Sof crashes?

If you create a new project on your own, this situation will not occur,But if you copy the existing project to modify, such as copy de2/DE2-70 itself to modify the routines, this problem may occur.

Solution
Step 1:
Check whether the route entries of programmer are correct.

If you copy the existing project to change it, it is likely that programmer still points to *. Sof release of the original project.

Step 2:
Check whether the project category of the production sof still points to the original project category.

Assignments-> Settings: compilation process settings: SAVE project output files in specified directory

Conclusion
This is a simple and difficult decision-making piece of information, which was previously met by netizens, he said that he could not find the reason for getting stuck for a long time. Today he was lucky and met again, so he remembered to share with you.

See also
(Original) How can we determine the invalid parameter information of the "leaving target processor paused" of the niosii? (IC design) (Quartus II)
(Original) How can we determine the valid parameter information (ii) of the "leaving target processor paused" of the niosii )? (SOC)