The previous article describes how to make an engine Appliance. How do you use it when appliance is made? The following is a detailed introduction to the use of engine appliance.
First, we need a physical server on which to install the CentOS7.0 operating system first. Then configure it according to the following steps:
(1) Configure the network
ip:192.168.14.67netmask:255.255.252.0gateway:192.168.14.1
(2) Configuring Domain name Resolution
192.168.14.67 node.test192.168.14.77 Engine.test
(3) Configuring the Yum Source
A, CentOS7 source (use the latest source on the Internet) B, oVirt3.5 source # RPM-IVH http://resources.ovirt.org/pub/yum-repo/ovirt-release35.rpm
(4) Installing the Ovirt-hosted-engine-setup package
# yum-y Install Ovirt-hosted-engine-setup
This article is from the "Blackart" blog, make sure to keep this source http://blackart.blog.51cto.com/1142352/1561888
Ovirt Special topic: Hosted Engine Appliance Use (1)