To give you painter software users to detailed analysis to share the plot of realistic character effects of the tutorial.
Tool: Pencil 2.4pix light gray.
1th step, Structure diagram: 2B pencil (2.4pix).
First, according to the original sketch outline of the face structure, no need to fine painting. It is important to accurately locate the facial features and proportions.
2, line draft figure: 2B Pencil (2.4pix).
According to the structure of the smooth, rich lines, as shown in figure I:
After the completion of the line, detailed and original comparison. Observe and master the characters in the original image and modify the defects in the line draft.
3, complete the line draft
The choice of color often and the original artwork will be some discrepancy, as far as possible to choose near color. Try various color selection and adjust each, can enlarge the visual comprehension ability.
Select "Airbrushes (airbrush)---Detail airbrushes (fine jet pen)"
Size (size): 34.9 optcity (opaque): 23% (can be set according to personal preferences)
5, the overall spread of light red bottom. Spray the brush to go casually, but the whole should be evenly.
6, find the high light area, still use the spray gun, the size of transparent basic unchanged or appropriate reduction, smear the high light area. Brush toward the cheekbones to the back of the cheek spread to the back, pay attention not to apply to the backlight area
Note: A, do not apply white directly, choose the transparent bottom of the white in the area of large smear.
b, reduce the size of the gun, increase transparency smear. As the first two steps to gradually deepen the brightness of white or dominant, the higher the transparency, the smaller the size of the gun.
C, in more than two color interface processing: Choose "blenders (brush)----Detail Blenders 3 (details of the mixed pen 3)" Here "optcity (opaque)" Principle of control: the higher the transparency, two color transition belt more obvious, the lower the transparency, The less obvious the color transition zone
8th step to deepen the dark area
In front of the line draft, the overall completion of the line map than the original figure is very old, in the use of light pink, based on the combination of dark area curve using a gray, coffee complementary.
The color of the visual feeling I'm not here. I'm not tired of it, the colour sense is fashionable, noble, Gray is mainly to play the bottom of the dark area.
First of all, in the dark area covered with light gray, the same is the gun, increase size, reduce transparency (about 10%). About the size of the gun, as far as possible to estimate the approximate brush area, brush too small prone to create uneven color, too large spread to other areas, turn back and get the school color.
On a light gray basis, fill in a layer of light pink (the beginning of the basic pink) pressure (gray) color, and then spread light brown. The closer the ear, the darker the color. Finally, use the "brush----details Fusion 3" to gently apply the balance of the color belt convergence.
"Details mixed pen 3" brush direction (see below): 1, the main complement to 2, face light to 3, transition belt trend
First with a light brown spray gun with the first 1/3 eyebrows (hair) head, thick covered the whole eyebrows. Then adjust the color to dark brown at 2/3 and start back brush. Then adjust to the brown line of dark black to pull to the end of the eyebrow. Finally cut to the most fine strokes to outline the eyebrow tip.
is basically a shallow----deep----black process.
This is the process of giving the eyebrows a bottom, and does not finish painting the eyebrows.
10, reduce the size of the pen to 1pix or so, according to the eyebrows to brush eyebrows, where the color settings, in the brow light, sparse, sketch a few strokes on it, color should be as far as possible and the brow of the color staggered.
11, if it is more detailed drawing, according to the following direction to the thrush head. This goes to my own figure because my eyebrows are a good example of observation:
Finally finished the eyebrows. I can also refine or modify
Use brown, spray gun 2pix, light to lay out the bottom line (see figure below)
13, black, spray gun 1pix, transparency 9%, add transition color (see figure below)
14, black, spray gun 1pix, transparency 99%, Portrait eyeliner (see below)
Note: In this depiction there is nothing to pay attention to, the only thing to note is that the color should be even, do not appear arch circle deformation, line break.
Of course, can also be directly to the last step of the description ~ ~ Don't forget to revise the form in the color draft (the specific approach is: Close the line manuscript layer, directly in the color manuscript to correct the form, to avoid relying on line map to do the map, and in the undo line, the color of the manuscript
15th Step: The portrayal of the eye
(On the color of the manuscript layer) to the high light area and dark area, highlights of the production method, as we said earlier, with white low transparent brush bedding, and then slow down the small brush, increase transparency, layer on the heap, in the high light with two head reduction transparency, in order to transition to a more smooth coffee
In this step, we learn to draw the level of the eyelids. On the basis of the original color, reduce the strokes, deepen the color, close to the top of the eye line brush a deep transparent belt, slightly smaller than the front of the brown belt.
The modification has always existed, not that we draw our eyes and draw our eyes, but after drawing the eyes, must be left and right eye contrast, and the overall color, composition coordination, and the original picture comparison, modify, as far as possible, even in the portrayal of local, also dissolve into the overall environment, isolated painting a certain part, it is easy to cause the draft, The workload was complicated when the final draft was completed.
On the issue of detail Description:
Sometimes we often talk about the details of the problem, or see a picture is always not clear, in fact, its volume does not feel strong. And if the simple color, and will feel very abrupt, then this detail to depict the problem, without too much to try to figure out what, its precursor is the light and dark practice of the sketch, mastered the sketch of the Light and shade, this part is very easy to start.
It's not that we don't use white when we should. also used, but the feeling is not good, simple, white paint on the feeling is not strong, or simply do not see, and in black painted white is very obvious, wear is the background color contrast problem
Continue to deepen the color, adjust (left, right) eye (box) fluency
Smear the high light area of pupil and pupil according to the line draft. About the high light area this point, must carefully decompose the original picture, White is extremely high brightness, has the absolute influence to the eye portrayal
Taking into account the pupil's perspective (round), in the white that similar to the long square high light area, using a fan-shaped painting
The left eye color is brown, the school color, a little red, continue to adjust the symmetry of the eyes.
We've been using the airbrush, the pencil, the Smudge tool, where we try to paint the lashes with a fork brush, with a pencil can also be painted, since there are brushes with brush, slowly penetrate a variety of brush properties, a lot of PT Brush, one of the special to learn very tired, slowly to master their respective characteristics.
The brush settings are displayed in the toolbar on the top right corner of the picture.
About two points of eyelash:
1, perspective, is the root of the eyelash is thick, the tip of rare
2, brush direction of arc-type Valgus
3, sketch a few obvious black eyelashes (observe the original image of the eyelash characteristics), (in the left eye and right eye lashes have a very good contrast, brush brushes forget, in fact, the left eye lashes is to do a few steps above, the right eye to try to use a pencil, painting forgotten, also lazy modified)
The general painting of the eye, in fact, in this detail there are many rough place, if a little bit of the pursuit of perfection, but also need to spend more time.
The painting is a bit annoying, so temporarily put up, continue to draw other places, have time to change a little bit
In the process of painting, encountered a lot of difficult difficulties, only 1.1 points to try, in the original based on constantly try new techniques and creations, the ultimate ability to play, is the growth (cooked) process.
Outline of the 22nd step of the bridge of the nose.
On the original image, it is easy to find the middle of the nose belt is red, slightly deeper than other parts, creating a protrusion of the feeling. If you are more rigorous, layer by layer of different transparency heap up.
In the image below, the color of the nose, the border, the edges, and the brush (red shoulder) are decomposed. After using the airbrush to brush out the red, follow the red shoulder to the smudge tool down, side, outside to the inner smear and fusion transition, retain the color area.
On the direction of brush, as far as possible to follow and combine the distribution of muscle and light radiation source
23rd step, find the nose of the Dark Belt (area) contour
24, Color Manuscript correction
25th Step: Continue to smear the color of the light and shade, and lay the first layer of nasal bottom color, for the establishment of three-dimensional nasal preparation
26, continue the Color connection processing, sketch the nose root shadow
27, the nostril spreads the color
28, deepen nostril. Continue to depict the tip of the three-dimensional, color continues to deepen, brush toward upward.
29, the current final effect
30th Step: The depiction of the lips
In the past in flash painting, feeling in the color expression, I am very good at. In the first time in the PT to do the painting, only to find the color of the poor, the PT and flash painting is different, because the software's own characteristics and constraints, the color of the PT can be freely reconciled to play, in Flash this can be done, but not as high as the PT expression.
Initially looking for color is very difficult, almost in the color picker can not find the desired colors, only in the mixer 1.1 points of the harmony, a bit like and mud, add the eye can see in the picture of any color feeling, and then reconcile, 1.1 points to find the feeling. Here is the lips outside the edge color, after looking at the picture, found that her lipstick has the outer halo Tendency, chose the tint from the outward middle accumulation
First brush the outside lip angle line with the first pen
(Here I'm pouring a pen.) PT painting is generally from the back of the drawing, that is, you see the nearest thing, is the last sketch of things, the farther the more things first, I do not draw teeth, and first painted lips, this lip is very challenging.
31st Step: Tile Lip Bottom
Use the Smudge tool to blend colors and bottom. Avoid opening the high light zone
32nd step to deepen the color of the lip, and brush direction
(painting here, feel your vision finally balanced a little, see red)
33rd step, continue to depict the level (note brush direction)
The 34th step Bright light Construction
Here, the brush has changed. The brush function of PT is very powerful indeed. Here to decide the reason for the brush is: 1, this picture of the high light area can not be used to complete the gun, the choice of chalk, chalk is very strong particles. 2, break the smooth feeling of the picture.
A few strokes of white light on the upper lip
Lower lip first with white spray gun bedding, and then use light white chalk combined with the original picture of the high light distribution sketch
(Large picture please enlarge and view)
35th step, continue to adjust the level and volume sense
Use white and red to sketch each other (pressure color), deepen the description of the dark area of the lip corner. One thing to note here is that the left and right corners of her lip are not equal, with a smiling structural perspective on the right, and not on the left. Therefore, in the adjustment, special attention should be paid to the positioning and performance of the high light area.
Brush direction: (shown in the Red arrow in the figure)
38th: Strengthen contour Line
First of all, the dark gray spread hair and face contact with the junction, in turn to deepen outward, the outermost is black. The color is fused from the inside to the outside.
40th Step: Sketch The Hairline
Reduce spray gun strokes to 1.0pxi, use light gray from the face to the hair direction of the small hairline, gradually deepen color, size unchanged
41st step, remove the redundant (merged) line of the layer and each color, and then adjust again.
The painting is basically finished here, the finished painting is rough draft, the details still need to be portrayed again, but nothing more than to strengthen the intensity and intensity, to correct some of the problems left over before.
A few noteworthy questions:
1, in the painting process, as far as possible to complete the local problems, do not accumulate too many problems to modify, otherwise the amount of modification will be very large.
2, color as far as possible positioning accurate, coordination. When drawing eyebrows, think of the coordination with the overall color. When drawing eyes, to think with eyebrows, the overall color coordination, so, step by step to coordinate the relationship between the local and the whole.
3, for the difficulty of the place, in the beginning do not have too much restraint, can be appropriate to put a place, do not pay attention to details, and put more energy. Sometimes it's better to put it down and pick it up.
4, in the process of coloring do not deliberately to pursue the details of the performance, the details of the sketch is endless. The second is not a simple to paint the local details, because in the overall draft, but also to coordinate the relationship with the whole, it may be in obedience to the overall basis of the fine, or you are tired to death, the results can not obey the overall relationship, but also modify.
Well, the above information is small make up to you painter of this software users brought to the detailed rendering of realistic character effect of the tutorial to share all the content, you see the users here, small series believe you are now very clear method of it, Then you go to follow the small series of tutorials yourself to try to draw down.
