Performance in Wan with Shunra VE SMB test system (such as video surveillance, building intercom, VOIP, IPTV, etc.)

First, Shunra VE SMB Introduction
Shunra ve SMB Edition is a network simulation software product designed for small and medium sized enterprises, Shunra ve SMB Edition simulation software can be used to test, compare or predict under different network conditions-including delay, jitter, Packet loss and bandwidth (max. 10Mbps)-performance of the application or device.
The software can be used to test the performance of video surveillance, building visual intercom, VOIP, IPTV, etc. running in the network. The operating condition of the system is simulated with certain delay, jitter, packet loss rate and bandwidth limitation.
Second, Shunra VE SMB Installation Environment Introduction
Install Win2003 server, and to install two network adapters, set the router mode as shown in.

The diagram above shows open Routing and Remote Access, setting the machine to router mode as shown in.
Download the link for Shunra VE SMB Enterprise Edition as follows:
http://download.csdn.net/detail/flyeagle022/8873311
This test case is a system, there are two terminal A and b,a terminal to the B terminal to send real-time audio and video data, the need to test the two terminal in the network bandwidth, packet loss rate, delay, jitter and other network parameters are affected by the system's adaptability.
Install two network adapters in Windows2003 server, as shown in the following table:

1. Local Links: 192.168.168.2,255.255.255.0

2. Local link 2:192.168.1.113,255.255.255.0

   Be careful not to set the gateway!!!
   In order to connect terminals A and B on two NICs respectively, two additional static routing tables are required:

   
   Represents the ability to route from 192.168.1.113 to 192.168.1.0/24 network through Gateway 192.168.168.2.
   
   Represents the ability to route from 192.168.168.2 to 192.168.168.0/24 network through Gateway 192.168.168.113.
   Where Terminal a address is set as follows:
   ip:192.168.1.103,gw:192.168.1.113
   Use a network cable to connect directly to the "Local Area Connection 2" network card.
   The terminal B address is set as follows:
   ip:192.168.168.100,gw:192.168.168.2
   Use a network cable to connect directly to the "Local Connection" network card.

   Then ping the other terminal on Terminal A or B and check it out.

Three, start Shunra VE, implementation.
As shown, start Shuanra VE, according to the parameters of the function area, set the required parameters, mainly this version of the bandwidth on-line only 10M, set the parameters, direct F5,GO!!!
You can observe the data in each window, according to the performance parameters of the project itself, judge your project performance indicators, you know!

END!

Copyright NOTICE: This article for Bo Master original article, without Bo Master permission not reproduced.

Performance in Wan with Shunra VE SMB test system (such as video surveillance, building intercom, VOIP, IPTV, etc.)