Photoshop adds a refreshing lavender-red tutorial to the exterior beauty

A good PS tutorial, there is a need to know friends can refer to this article Oh, original

< small map view big picture >

Final effect

1, open the material picture, create hue/saturation adjustment layer, the appropriate reduction of picture saturation, parameters and effects as shown below. This step appropriately reduces picture noise.

< map 1>

< map 2>

2, create curve adjustment layer, RGB, red, green, blue to adjust, parameter settings such as Figure 3-6, the effect is shown in Figure 7. This step appropriately increases the brightness of the picture and adds Blue purple.

< map 3>

< map 4>

< map 5>

< map 6>

3, press CTRL + J the current curve adjustment layer copy one layer, the opacity to: 50%, the effect of the following figure.

< map 8>

4, the creation of optional color adjustment layer, red, neutral, black adjustment, parameter settings such as Figure 9-11, the effect is shown in Figure 12. This step adds red to the picture.

< map 9>

< map 10>

< map 11>

< map 12>

5, create curve adjustment layer, RGB, red, blue adjustment, parameter settings such as Figure 13-15, the effect is shown in Figure 16. This step to fine-tune the color of the picture.

< map 13>

< map 14>

< map 15>

< map 16>

6, press CTRL + ALT + 2 to bring up the high light selection, press CTRL + Shift + I to select a new layer fill dark red: #927378, blending mode to "filter", the opacity to: 20%, the effect of the following figure. This step increases the brightness of the dark part of the picture.

7, create an optional color adjustment layer, red, yellow, green, magenta, white to adjust, parameter settings such as Figure 18-22, the effect is shown in Figure 23. This step mainly to the picture of the high light part of the increase in light cyan.

< map 18>

< map 19>

< map 20>

< map 21>

< map 22>

8, create color balance adjustment layer, shadow, highlight adjustment, parameter settings such as Figure 24,25, after the layer opacity to: 30%, the effect of Figure 26. This step is to fine-tune the color of the dark part and the high light portion of the picture.

< map 24>

< map 25>

< map 26>

9, create a new layer, press CTRL + ALT + Shift + E stamped layer, appropriate to the picture soft processing, the method optional, the approximate effect of the following figure.

< map 27>

10, create an optional color adjustment layer, the red adjustment, parameters and effects of the following figure. This step strengthens the red in the picture.

< map 28>

< map 29>

11, a new layer, stamped layer. CTRL + Shift + U go color, blending mode to "multiply", opacity to: 45%, and then hold down the ALT key to add a layer mask, with a white brush to the bottom need to deepen the part of the wipe out, the effect of the following figure.

< map 30>

Finally, simply rub the skin of the character, fine-tune the lip and the overall color, complete the final effect.