Photoshop adds a soft, neutral yellow green to the beauty of the lawn

The main color of the material picture is mainly dark green, not soft enough. Before processing, you can turn the dark color down a little, and then the main color into their favorite color, and then add a little bit more light, so that the overall look softer.

　　Original

　　Final effect

1. Open the material picture, create the optional Color adjustment layer, adjust the green, and set the parameters as follows. This step adds green to the picture.

< map 1>

2, create a new layer, press CTRL + ALT + Shift + E-stamp layer, enter the channel panel, copy the red channel, press CTRL + I to reverse the red Copy channel, and then press CTRL + M to adjust the contrast of light and shade, and then hold down CTRL and click the red Copy Channel to load the selection.

< map 2>

3, back to the layer board, create a color balance adjustment layer, shadow, midtones adjustment, parameters and effects of the following figure. This step deepens the darker color.

< map 3>

< map 4>

< map 5>

4, create an optional color adjustment layer, the yellow, green adjustment, parameter settings such as Figure 6,7, determined to press CTRL + ALT + G to create a clipping mask, the effect is as shown in Figure 8. This step turns the dark green to yellow-green.

< map 6>

< map 7>

< map 8>

5, press CTRL + J to copy the current optional color adjustment layer, the opacity to: 30%, also press CTRL + ALT + G to create a clipping mask, the effect of the following figure.

< map 9>

6, create curve adjustment layer, RGB, red channel adjustment, parameter settings such as Figure 10, determine the same method after the creation of clipping masks, the effect is as shown in Figure 11. This step lightens the dark color and adds warm colors.

< map 10>

< map 11>

7, press CTRL + J the current curve adjustment layer to copy one layer, the opacity to: 50%, and then the same method to create a clipping mask, the effect of the following figure.

< map 12>

8, press CTRL + ALT + 2 to bring up the high light selection, create an optional color adjustment layer, yellow, green, white adjustment, parameter settings such as Figure 13-15, the effect is as Figure 16. This step adds orange yellow to the high light portion.

< map 13>

< map 14>

< map 15>

< map 16>

9, create hue/saturation adjustment layer, the yellow adjustment, parameters and effects as shown below. This step turns yellow into orange in the picture and lowers the saturation.

< map 17>

< map 18>

10, press CTRL + ALT + 2 to bring up the high light selection, create a solid color adjustment layer, color set to light yellow: #FFFEF1, to determine the blending mode changed to "soft light", the opacity to: 10%, the effect of the following figure.

< map 19>

11, create curve adjustment layer, RGB, red, green, blue channel adjustment, parameter settings such as Figure 20-23, the effect is shown in Figure 24. This step mainly to the image dark color dimming, and to the high light part of the increase in light blue.

< map 20>

< map 21>

< map 22>

< map 23>

< map 24> categories:

• PS Image Processing