Photoshop adds a sweet early spring light green to the beauty on the lawn

The material picture is also mainly green, but the character part is not sweet enough. When dealing with the green light a little, the dark part of a little brighter, and then the character of the skin tone ruddy.

Original

Final effect

1, open the material picture, create an optional color adjustment layer, yellow, green, neutral, black adjustment, parameter settings such as Figure 1-4, the effect is shown in Figure 5. This step mainly in the picture of the yellow-green slightly diluted a little.

< map 1>

< map 2>

< map 3>

< map 4>

< map 5>

2, press CTRL + J to copy the current optional color adjustment layer, the opacity to: 50%, the effect of the following figure.

< map 6>

3, press CTRL + ALT + 2 to bring up the highlight selection, press CTRL + Shift + I to select, then create a color balance adjustment layer, adjust the shadow, midtones, highlights, parameter settings such as Figure 7-9, the effect is as Figure 10. This step adds a little warm color to the dark part of the picture.

< map 7>

< map 8>

< map 9>

< map 10>

4, create curve adjustment layer, the RGB, green, blue channel adjustment, parameter settings such as Figure 11-13, determined to press CTRL + ALT + G to create a clipping mask, the effect is shown in Figure 14. This step is a slight dimming of the dark color.

< map 11>

< map 12>

< map 13>

< map 14>

5, create hue/saturation adjustment layer, the yellow adjustment, parameters and effects as shown below. This step appropriately reduces the yellow saturation in the picture.

< map 15>

< map 16>

6, create an optional color adjustment layer, red, yellow, green, white to adjust, parameter settings such as Figure 17-20, the effect is shown in Figure 21. This step then the yellow-green light in the picture, while adding red to the picture.

< map 17>

< map 18>

< map 19>

< map 20>

< map 21>

7, create curve adjustment layer, RGB, red, green, blue channel adjustment, parameter settings such as Figure 22-25, the effect is shown in Figure 26. This step adds a light green to the picture.

< map 22>

< map 23>

< map 24>

< map 25>

< map 26>

8, a new layer, fill light green: #D7E4A3, blending mode to "filter", add layer mask, with black and white gradient from the upper right corner to the lower left corner pull white to black linear gradient, the effect of the following figure. This step adds a high light to the picture.

< map 27>

9, if the highlight is not obvious enough, you can copy the current layer layer, the appropriate reduction of layer opacity, as shown below.

< map 28>

10, the creation of optional color adjustment layer, yellow, green, white adjustment, parameter settings such as Figure 29-31, the effect is shown in Figure 32. This step adds a light green to the picture.

< map 29>

< map 30>

< map 31>

< map 32>

11. Create a new layer, press CTRL + ALT + Shift + E-stamped layer, simply rub the skin on the character, and then use the Blur tool to properly blur the background locally. The dark part of the character is deepened slightly with a deepening tool.

< map 33>

12, create an optional color adjustment layer, red, yellow, white to adjust, parameter settings such as Figure 34-36, the effect is shown in Figure 37. This step adds red to the character's complexion and adds light cyan to the high light portion.

< map 34>

< map 35>

< map 36>

< map 37>

Finally, fine tune the color, the character part of a slightly darker, complete the final effect.

Category:

• PS Palette Tutorial