Photoshop Change Avatar Tutorial

Material A

Material two

Final effect

Look at other people do things really good, they also want to small test, hehe, if violated the portrait of a comrade, maybe I was on purpose, please brother table flat me.

1. Open "Material One", "material two" with the Pen tool to check out the "Material two" Avatar section, press Ctrl+enter to pull out the selection, and then press CTRL + C copy avatar part of the following figure

2. Back to "material two", press CTRL + V to "material one" part of the avatar copy over, with the arrow tool to move to the appropriate position as shown below

3. Adjust the head color balance, into the image (image)-> adjustments (adjust)-> color Balance (color balance), this step is the most critical, the need to mix the layer and the new layer color matching, in this case, select the Midtones and adjust the Color levels to +40, 0, 0:

4. Then select Highlights and adjust the Color levels to +100, +60,-40:

5. According to ctrl+t appropriate adjust the size of the head, so that he can merge with the image below.

6. Enlarge the picture after the carriage return, now handles the seam place, selects the key seam place:

7. You can use the Blur Tool (Blur tool) or filter (filter)-> Blur (Blur)-> Blur (blur) for processing, only a few times the same operation can be repeated:

8. Select all parts of the layer and select filter (filter)-> noise (Noise)-> despeckle (speckle), try to observe the effect:

9. Then select Select (Select)-> Modify (Modify)-> Border (extension) and set a value of: 4, continue to use the filter (filter)-> Blur (fuzzy)-> Blur (fuzzy) repeat several times:

10. Adjust the size and inclination of the head appropriately, and make the effect to oneself satisfied.

Classification:

• ps Picture processing