The tutorial's wallpaper needs to be completed in two steps. The first is the background part of the production, this step is more important, the background part of the color range will control the display area of the spot. The color and color block area should be properly controlled when making. Then is the production of spot light, this step is relatively simple, in the part of the background with the need to add the desired spot, the appropriate change in the layer blending mode can be.
Final effect
Photoshop Tutorials
1, create a new 1024 * 768 pixel document, background fill black. To create a new group, let's make the background section first, and the effect needs to be done as shown below.
< map 1>
2. Create a new layer in the group, use the elliptical marquee tool to pull out the positive circle selections shown in the following figure, press CTRL + ALT + D to feather 25 pixels, and then fill in the dark purple.
< map 2>
3, remove the selection after the CTRL + T deformation treatment, appropriate flattening and stretching a little, the following figure.
< map 3>
4, the good color block properly put the position, the following figure.
< map 4>
5, color block can be reproduced and deformation processing, you can also fine-tune the color, as shown below.
< map 5>
6, the partial color block may suitably cut, the following picture.
< map 6>
7, the same method to make more color block, appropriate adjustment of color and size.
< map 7> categories:
- PS Getting Started Tutorial