Photoshop Photo-Repair face clean

We often find that the face of the photo has spots, how to repair these miscellaneous points, back to the original picture? Many people are accustomed to using the filter "away clutter" or using the "smudge tool" for processing, but the effect of using them is not ideal, and time-consuming and laborious. Below, I'll take an example to illustrate the fastest, best way to spot a speckle, and in the process, you'll also get some use of the channels in Photoshop.

Figure 1

Look at the original image (figure I), it is obvious that the characters face a lot of spots. We open the picture in Photoshop switch to the "channel" panel, the picture is RGB mode, we can see that the picture has four channels, respectively, RGB mixed channel and R (Red), G (green), B (blue) color separation channel.

Figure 2

Click on each channel, you will find the miscellaneous points in the GB channel more, and the R channel just can select the face and other. Hold down CTRL and click on the R channel to load the selection we want to repair. As shown in Figure II:

Figure 3

Make appropriate special blur for selected parts (smart Blur):

Figure 4

The parameters are shown in Figure four and can be adjusted by themselves (note: the original selection and channel are still reserved)

As mentioned above, there are more miscellaneous points in the G and B channels. We switch to the G (green) channel, that is, click this channel, keep the original selection, do the same operation as the R channel, because the miscellaneous points are more, where we use the same two special blur (note: The use of two radius of 1 fuzzy and the use of a radius of 2 fuzzy effect is different) ... In the process you can obviously feel the disappearance of the clutter ...

Similarly, switch to B channel, also with two times special blur ... Here you click on the RGB mixed channel to view the whole picture, you will find the face of the stray point has not been.

Figure 5

Next we adjust the face and the hair of the light and shade and color, to reflect the image of the level of feeling. We first adjust the face to keep the original selection (if the selection disappears, just hold down CTRL and click the R Channel), and press Ctrl+m to adjust the curve (Figure V):

And then reversed, the hair and other parts of the curve adjustment, dimming some. This is all done.

In this method, no tools are used, except for the "special blur" in the filter. It is noteworthy that: 1, the selection of the problem, how to use the channel to select the location to be repaired is the key, 2, according to the number of stray points in each channel corresponding to varying degrees of ambiguity.